Disposal of the appliance
Under no circumstances should you
dispose of the appliance with normal
domestic waste. This product is subject
to the provisions of European Directive
2012/19/EU.
Dispose of the appliance via an approved disposal
company or your municipal waste facility. Please
observe the currently applicable regulations.
Please contact your waste disposal centre if you
need any further information.
Disposal
Disposal of batteries
Used batteries may not be disposed of
with household waste.
All consumers are statutorily required to dispose
of batteries at a collection point provided by
their local municipality or retail store.
The purpose of this obligation is to ensure
Notes:
·
The push button and receiver can connect with
a range up to 100m/300ft without any
obstacles.
·
The push button’s transmitting frequency is
433MHz and its range can be affected by metal
,walls, concretes, and interfering signals from
other electronic appliances with the same
frequency including televisions, radios, and
cookers.
·
Please do not install the push button and
receiver near to the above mentioned
electronic appliances.
·
Please test the operating range of the receiver
and push button in your home before
installation.
·
Do not install the push button and receiver near
any source of naked flames such as lighted
candles.
·
Do not expose the push button and receiver to
direct sunlight or high temperatures, otherwise
overheating may cause them irreparably
damaged.
- 13 -
- 14 -
c. Install the name plate:
Remove the transparent cover from the push
button.
Then write your name or room number on a
small paper (size: 2.3cm/0.9in x 2.0cm/0.8in).
Next, put the small paper into the transparent
cover and then put back the transparent cover
on the push button.
Note:
If you make the name plate by hand, be sure to
use a waterproof pen.
6. Trouble Shooting:
a. The receiver rings without the push button
being pressed.
The receiver may be matched on the same
frequency with nearby push buttons. You should
wipe the pairing and re-pair your push button(s).
b. There is no ring/LED flash when the push
button is pressed.
·
Check whether the battery (CR2032) is inserted
into the push button.
·
For the plug-in receiver,check whether the
power supply for the receiver is working
properly.
·
Pair the receiver and push button again.
·
For the battery-operated receiver,check
whether the batteries are inserted into the
receiver.
c. The ringtone volume is greatly reduced.
A weak battery can reduce the ringtone volume
of the receiver. Please change the battery every
10-12 months.
Metal constructions, walls, and other appliances
with the same frequency can also affect the
receiver’s ringing effect. Avoid mounting the
push button and receiver near any metal objects.
