16
17
7. Tighten the screws completely once the perfect alignment is achieved.
NOTE:
If you are unfamiliar or uncomfortable with completing this procedure, we
recommend consulting with a professional to perform the installation.
Technical Specifications
Turntable
Model
1-AD07US01,H005
Speed Variance
±1.5%
Nominal Speeds
33 1/3 & 45RPM
Wow and Flutter
≤0.15%
Effective Tonearm Length
8.6” (218.5mm)
Signal to Noise
55dB
Tracking Force Range
3.0-6.0g
Overhang
0.73in
Outboard Power Supply
12V/ 500mA AC-DC
Power Consumption
5W
AC Power Adapter
Input: 100-240V 50/60Hz, Max. 200mA
Dimensions (W x H x D)
16.34” x 10.2” x 4.44” (415 x 340 x 148mm)
Weight
13.67lbs (6.2kg)
Cartridge
Stylus Model
Audio Technica AT-3600L
Frequency Response
20Hz-20kHz
Recommended Load Resistance
47kohms
Channel Balance
＜
2.5dB
Amplifier Connection
MM - input
Channel Separation
＞
18dB
Recommended Tracking Force
3.5±0.5g
Output Voltage
2.5mV
Weight
5g
Potential Incorrect Use and Fault Conditions
This turntable is manufactured to the highest standards and undergoes strict quality
controls before leaving the factory. Faults that may possibly occur are not necessarily
due to material or production faults but can sometimes be caused by incorrect use or
unfortunate circumstances. Therefore the following list of common fault symptoms
has been included here.
There is no power:
- The turntable is not connected to the power adapter.
- No power at the outlet.
The platter doesn’t turn although the unit is switched on:
- The unit is not connected to the main power supply.
- No power at the outlet.
- Drive belt is not installed or has slipped off.
No signal through one or both channels:
- Phono input not selected on amplifier.
- Amplifier not switched on.
- Amplifier or speakers muted.
- No connection to the speakers.
- No connection between turntable and amplifier.
- Wire leads not connected the cartridge.
Strong hum on phono input:
- No ground connection from cartridge, arm, or arm cable to amplifier or ground loop.
- Turntable is too close to speakers.
Distorted or inconsistent sound from one or both channels:
- Turntable is connected to wrong input of the amplifier.
- Needle or cantilever damaged.
- Drive belt overstretched or dirty.
- Platter bearing without oil, dirty or damaged.
- Dust on stylus.
- MM / MC switch on pre-amplifier set incorrectly.
Cannot connect with Bluetooth speaker:
- The turntable is not in pairing mode.
- Your Bluetooth speaker is not in pairing mode.
- The Bluetooth transmitter has turned off because Bluetooth is not connected in 2
minutes.
