9/12/18 2:26 PM
Copyright 1010music LLC 2018
Mute Effects
1.
While on the Main screen, push the
HOME
button to enter mute editing mode. The grid cells will be green.
2.
Touch a cell to mute that effect. The cell will turn red. Touch it again to remove the mute.
3.
Push the
HOME
button to leave mute editing mode. A red bar appears over the names of muted effects.
Start and Configure the Step Sequencer
1.
Push the
HOME
button to return to the Main screen if needed.
2.
On the Main screen, touch the
Play
button to start and stop the Step Sequencer as needed.
3.
With the
Play
button selected, push the
INFO
button to see the step sequencer parameters, including
Step Count
and
Step Duration
.
4.
Adjust a parameter by turning the control knob next to it.
5.
To run the sequencer constantly, set the
Sequencer
parameter to
ON
.
Sequence an Effect
1.
Push the
HOME
button to return to the Main screen if needed.
2.
Select an effect to sequence by touching the grid cell.
3.
Push the
INFO
button twice or thrice until the
Step Sequencer
screen is displayed. A box
outline moves across the grid to represent the currently playing step of the sequencer. The
number of boxes the sequencer moves through is controlled by the
Step Count
parameter.
The time spent in each box is controlled by the
Step Duration
parameter.
4.
Touch the grid boxes on the touch screen to enable and disable the gate for the effect on
each step. The effect is enabled for the step when the grid box is highlighted blue.
Visually Monitor the Effects
The grid on the Main screen shows when the effects are active via a bar that is displayed below the name of the effect. If the bar is
filled, the Step Sequencer or a
CV Trigger
input triggered the effect. If the bar is unfilled, the effect is active because the
Trigger Mode
parameter for the effect is set to
ON
.
Modulate Effect Parameters
Some of the effects have parameters that can be modulated using the External CV Inputs EXT1 through EXT8.
1.
Plug an external CV signal into one of the top three
CV Modulator
jacks. A bar graph appears along the bottom of the
corresponding
MOD
button that represents the value of the CV input.
Note
:
•
The right most column of CV Modulator jacks map to EXT1 through EXT4. Ext5 through EXT8 are in the column to the left
of that. EXT5 through EXT8 also control the trigger for the corresponding effects grid cells. EXT4 also controls playback.
2.
Touch an effect cell and press
INFO
to see the parameters screen for this effect.
3.
Touch one of the three black boxes below a parameter to display the Modulation Parameters screen.
4.
Use the Control Knobs to select a value for the Source parameter. This parameter specifies which signal will be used to control
this parameter.
5.
For example, choose a
FILT
effect cell, then choose one of the modulation squares below the
Cutoff
parameter. Then set
EXT1
as the Source of modulation to use CV voltage to adjust the cutoff value of the FILT effect.
6.
Turn the
Control Knob
next to the
Amount
parameter to adjust how much impact the CV signal will have on the effect.
7.
The destination effect must be active to hear the impact of the modulator changes. Follow the steps under Apply Effects
above to activate the effect.
Learn More
Download the user manual from
1010music.com/fxbox-support
to learn about multiple effects chains, activating the XY Pad,
swapping firmware and other advanced features.
Be sure to check for any firmware updates and join the community by registering at
forum.1010music.com
.
This guide was written for fxbox 2.0.3.
Step Sequencer Screen
