9/12/18 2:26 PM
Copyright 1010music LLC 2018
Fxbox 2.0 Quick Start Guide
Before You Start
A microSD card must be inserted into fxbox before you
can get started. By default, fxbox takes audio input
from IN1 and IN2, processes the configured effects,
and sends the result to OUT1 and OUT2. The firmware
and all settings are stored on the microSD card.
Apply Effects
When fxbox starts up, it displays the
Main
screen with the effects
grid for Chain A of the loaded preset. Activate an effect by doing
one of the following:
•
Touch a cell on the touch screen to momentarily enable that
effect.
•
Trigger the effect via CV signal by plugging a gate signal
into the CV Trigger jack that maps to the effect in the grid.
•
Set the effect to be always on by setting the
Trigger Mode
property for the effect to
ON
by following the steps below. (Not
all effects have a trigger property.)
Edit the Parameters of an Effect
1.
Touch an effect cell on the
Main
screen.
2.
Push the
INFO
button.
You will see effect specific parameters, such as
Cutoff
and
Res
.
3.
Adjust a parameter by turning the
Control Knob
next to it.
Note
:
•
The signal processing chain applies the effects in the order displayed on the grid, from
left to right, then top to bottom.
Add or Change an Effect
1.
Touch a cell on the main grid to select it. Touch an empty cell to add a new effect to the
chain.
2.
Press the
INFO
button to display the parameters screen.
3.
Touch the effect type button in the top row (
FILT
in the example on the right) to display the
effects list, and then touch an effect to select it. The parameters screen changes to match the
effect type.
Note
:
•
Most effects can be used more than once. All effects can only be used a limited number
of times, corresponding to the relative processing power needed. An effect will be
disabled in the list if you cannot use more of that effect type.
Select a Preset
1.
From the Main screen, cycle through the list of presets by touching the
–
and
+
buttons on
either side of the preset name (
Just Fun 2
in the Main Screen example shown above).
2.
To select a preset from the list, touch the preset name at the top of the Main Screen to
display the Presets screen.
3.
Select a preset by scrolling through the list with any of the Control Knobs, and then touching
Load
in the top right corner of the touch screen.
Save Changes to a Preset
Fxbox 2.0 does not automatically save changes as you work. If you change to a different preset or turn
off fxbox, you will lose your work. If you want to keep the changes you made to a preset, you will need to save them:
1.
Press
HOME
until you see the Main screen.
2.
Touch the preset name at the top of the screen to display the Presets screen.
3.
Touch
Edit
to display the Edit Preset Menu.
4.
Touch
Save
to store your changes to the currently loaded preset, or
Save As
to save to a different preset.
Main
Screen
Presets Screen
Parameters Screen