Installation of E-Clip
(#2 and #3)
1. If necessary, remove existing E-Clip
(#3) by prying it away from the pin
with a flat head screw driver.
2. To install a new E-Clip (#3), place
the E-Clip (#3) on the surface of the
tool with it’s opening positioned
around the groove of the pin. Use
needle nose pliers to push the
E-Clip (#3) onto the pin until it
snaps into place. (Note: The
E-Clip will rotate freely but should
not come off without prying with
force.) Follow same procedure
for E-Clip #2 (see above diagram
for E-Clip #2 location).
Replacing Batteries (#1)
1. To replace the batteries, (that
power the LED light), use a Phillips
head screwdriver to remove the two
screws that hold down the cover by
rotating them counter clockwise.
2. Gently move the battery cover
to the side, exposing the two
batteries, which are stacked one on
top of the other. Be careful not to
damage the wire that’s attached to
the battery cover.
3. Remove both batteries but leave
the spring installed in the bottom
of the battery compartment (large
side of spring faces down).
4. Place the two new batteries (#1)
into the battery compartment, one
on top of the other, with the + side
facing down.
5. Carefully move the battery cover
over the batteries and line up the
screw holes. Use your thumb to
press the battery cover against
the tool to overcome the tension of
the battery compartment spring.
With the battery cover held firmly
in place, insert one of the screws
into the rear hole and tighten it
down, clockwise, halfway with a
Phillips head screwdriver. Insert
the remaining screw into the front
hole and tighten it down, clockwise,
fully. Return to the rear screw and
tighten it down fully. Engage the
jaws, to verify that the LED light
operates properly.
Kit Includes:
1. Batteries, Qty. 2
2. E-Clip (larger), Qty. 1
3. E-Clip (smaller), Qty. 1
4. Spring/Pin Jaw Retainer, Qty. 1
5. Jaw Stop Screw, Qty. 1
6. Reverse Thread Screw, Qty. 1
7. Guide/Stop Washer, Qty. 1
INSTALLATION INSTRUCTIONS
QCRTLDMRKIT-1 -
Small Parts Repair Kit
For QCRTLDM - Large Diameter Compact Crimp Tool
1
2
3
4
4
5
6
7
1
1
2
3
4
7
5
6
Watch our
PEX Tool Repair Video
on our One Zurn YouTube Channel.
