![background image](http://html1.mh-extra.com/html/zubler/variostar-series/variostar-series_instructions_942107001.webp)
Distributed by:
Zubler Gerätebau GmbH
Buchbrunnenweg 26
D - 89081 Ulm-Jungingen
Tel.: + 49 (0) 731 - 14 52 0
Fax: + 49 (0) 731 - 14 52 13
www.zubler-group.de
Zubler Gerätebau GmbH
Buchbrunnenweg 26
D - 89081 Ulm-Jungingen
Tel.: + 49 (0) 731 - 14 52 0
Fax: + 49 (0) 731 - 14 52 13
www.zubler-group.de
WORK SAFE
TY
when using r
otar
y t
ools
Important instructions and warning notes:
1. For your own safety, please read the operating manual before putting an appliance into operation.
2. Pay attention to the safety and work regulations of the employers mutual insurance association.
3. Provide good lighting, safety glass shields, eye protection and an effective extraction system at the workplace.
4. Check before starting up an electrical appliance if the mains voltage corresponds to the data on the type plate.
5. Remove the collet chuck and service tools before switching the device on.
6. Motor handpieces are intended exclusively for dry machining.
7. Check before using the motor handpiece if the tool is seated firmly and cannot be pulled out.
8. Use exclusively functional, certified tools (drill bits, milling bits, cutting disks, polishing tools, grinding tools, etc.)
and observe the tool manufacturer’s instructions for use, e.g. maximum permissible speed of rotation, and that the
tools are clamped over their entire length.
9. Make sure that the motor handpiece does not start unintentionally or run on unsupervised.
10. Operate the motor handpiece only with a clamped tool or pin.
11. Do not turn the collet chuck lock while the handpiece is rotating.
12. Clean the collet chuck regularly according to the instructions (never blow compressed air into the motor handpiece).
13. Use only rotating tools that are intended for use in dental laboratories and with the corresponding materials.
14. Set the handpiece to the desired speed before applying it to the workpiece to be machined.
15. When working with rotary tools, avoid levering or applying excessive working pressure (risk of overheating or tool
breakage).
16. It is essential to keep to the working speeds specified by the manufacturer.
17. Avoid overheating of the material that you are machining.
18. Place the motor handpiece in the handpiece holder after use. In this way you can protect the tools against breakage
and yourself against injury.
19. Clean the rotary tools regularly in accordance with the manufacturer‘s recommendations.
20. Repair and maintenance work on the electrical part of the appliance may be carried out
only by qualified technical personnel.
21. Electrical appliances may not be used in a damp or wet environment.
22. Appliances must be secured against unintentional use in case of defects or damage
where safe operation is no longer ensured.
B00246 / 11-2018