zView Assembly Instructions
for zSpace 200
1x
1x
1x
4x
1x
1x
770-00018-01 GUIDE, QUICK START, ZVIEW II REV D
1
Align bracket over the
4 threaded holes.
Insert and tighten the
4 M4 screws.
When aligning, make sure
threads are on lower half.
2
Thread knurled nut onto
the threaded end until
flush with the bottom.
3
4
Pull U stand out
before threading in
the flexible tubing.
Pull out to one of the
3 locking positions.
Preferably the 30
degree viewing angle
Thread knurled nut
until hand tight
5
6
7
Bend flexible housing to position that will allow web
cam to have clear view of user’s hand and the screen.
8
Insert flexible tubing and lock washer
between the back panel and U stand.
Thread tubing into the bracket.
For left side mount, have hose biased low. Once webcam is
installed, hose will be brought down to fine tune viewing
location. In doing so, hose will further tighten on to knurled nut.
For right side mount, have hose biased low. Once webcam is
installed, hose will be brought up to fine tune viewing
location. In doing so, hose will further tighten on to knurled nut.
1x
