Wiring:
1. One diode is an accessory provided in the accessory bag. The diode is used to prevent bounce-back current and voltage produced
during locking or unlocking from affecting the access control mainframe. Users can connect the diode to the wiring terminal in parallel.
Precautions:
1. Read this User Manual carefully before installing the electric strike.
2. Select qualified power source and wires to avoid insufficient locking force caused by abnormal power supply.
3. This lock has no delay function. If delay function is necessary, it shall be used together with the controller.
We lcome to use Advanced Lock products. In order to protect your rights and interests, read this User Manual carefully before use. Please contact the dealer or the
manufacturer in case of query.
AL-130 Series Electric Strike User Manual
Applicable Range
: This lock is applicable for use together with anode mechanical lock or ball lock in office buildings, wooden doors, stainless steel doors, fire doors and
entrance gate of residence community.
Product Advantage:
Recessed type installation and pleasant-looking appearance. The electromagnetic part adopts high-quality magnetic materials and special processing workmanship
to ensure normal use and no residual magnetism even after long time operation.
o
Door Opening:
90 and available for load of 250kg
Electrical Property:
Users can select appropriate products with different models and functions based on the following table. Customization is available according to users' requirements.
12V 15%
Model
Voltage (DC)
Current (mA)
AL-13 0N O
AL-1 30NC
240
120
Mechanical
Lock
3
3-5mm
1mm
AL-130 Series Electric Strike Installa tio n Drawing
Electric strikes
Electric
strike
28
88
3
68
34
135
149
39
21
35
(2000)量认(国)字(H0992)号
太平洋承保
质
AL-130NO
NC
GND
NO
PUSH
12V
GND
GND
12V
-
+
UPS
Control
NC NO
COM
NC
GND
NO
PUSH
12V
GND
GND
12V
-
+
UPS
Control
NC NO
COM
AL-130NC
-
+
-
+
Access control power source
N0 - unlock by
connecting power
NC - unlock by
disconnecting power
ELECTRIC LOCKS
Access controller
12V 15%
Customization is available for
products with 6-24VDC;
Access control power source
Access controller
Fig.1
Latch
Installation Precautions:
1.Allow a 1-2mm gap between the electric strike and the bolt of electric dropbolt. Otherwise, normal door
opening will be affected. (See Fig.1)
2.Allow a 3-5mm gap between the electric strike and the face plate of electric dropbolt. Otherwise, smooth
door closing will be affected. (See Fig.1)
Electric Strike Series
Magnetic Lock Series
El ect ric Bolt Lock ser ies
Brackets and Accessories
Me cha ni cal Lo ck Se riess
El ec tron ic Lo ck Se ries
Electric Strike Series
Magnetic Lock Series
El ect ric Bolt Lock ser ies
Brackets and Accessories
Me cha ni cal Lo ck Se riess
El ec tron ic Lo ck Se ries
Un lock Me thod
Door Frame
