Zennio inBOX DIM, Technical Documentation

Page: 1 / 4

© Zennio Avance y Tecnología S.L. Edition 1 Further information www.zennio.com
Page 1 / 4
inBOX DIM
Universal Dimmer for Flush Mounting - 1 Output (250W@230VAC / 200W@110V) / 2 A/D inputs
ZDI-IBD
Technical Documentation
FEATURES
▪
1 channel for R L C loads and for dimmable CFL and LED lamps.
▪
Automatic detection of R L C load type.
▪
Automatic frequency detection.
▪
Dimming pattern selection for CFL and LED lamps.
▪
Optional manual dimming control.
▪
2 inputs configurable as
▪
Binary input.
▪
Temperature probe.
▪
Motion sensor.
▪
10 logical functions.
▪
External 110/230VAC 50/60Hz power supply.
▪
Total data saving on KNX bus failure.
▪
Integrated KNX BCU.
▪
Dimensions Ø50 x 26mm.
▪
Can be mounted within distribution boxes, junction boxes or wall
back boxes.
▪
Conformity with the CE directives (CE-mark on the back side).
Programming/test button : short press to set programming mode. If this button is held while plugging the device into the KNX bus, it enters the safe
mode. If this button is held for more than 3 seconds, the device enters the test mode.
Programming/Test LED: programming mode indicator (red). When the device enters into safe mode, it blinks (red) every half second. The manual
mode is indicated by the green color. During the start-up (reset or after KNX bus failure) and if the device is not in safe mode, it emits a red flash.
1 . Output status LEDs 2 . Programming/Test button 3 . Programming/Test LED 4 . Inputs
5 . External power supply 6 . Output 7 . Output control buttons 8 . KNX connector
Figure 1. inBOX DIM
GENERAL SPECIFICATIONS
CONCEPT DESCRIPTION
Type of device Electric operation control device
KNX
supply
Voltage (typical) 29VDC SELV
Voltage range
21…31VDC
Maximum
consumption
Voltage mA mW
29VDC (typical) 8.2 237.8
24VDC
(1)
10 240
Connection type Typical bus connector TP1 for rigid cable 0.80mm Ø
External power supply 110/230VAC 50/60Hz
Operation temperature 0ºC to +40ºC
Storage temperature -20ºC to +55ºC
Operation humidity 5 to 95% RH (no condensation)
Storage humidity 5 to 95% RH (no condensation)
Complementary characteristics Class B
Protection class II
Operation type Continuous operation
Device action type Type 1
Electrical stress period Long
Degree of protection IP20, clean environment
Installation
Independent device to be mounted inside distribution boxes, junction boxes or wall
back boxes.
Minimum clearances Not required
Response on KNX bus failure Data saving according to parameterization
Response on KNX bus restart Data recovery according to parameterization
Operation indicator
The programming LED indicates programming mode (red) and test mode (green).
Each output LED indicates its status (fixed = active output; flashing = dimming error)
Weight 43g
PCB CTI index 175V
Housing material PC FR V0 halogen free
(1)
Maximum consumption in the worst case scenario (KNX Fan-In model)
3
6
8
2
4
1
7
5