Z-Wave Heating Thermostat SR-ZV9092A
09.ZV9092A.04770
Function introduction
Important:
Read All Instructions Prior to Installation
Front side
Product Data
F
TIME/SHIFT button, to set
time schedule of the
device quickly and move
the cursor
Function button, to
confirm, save setting
Mode button, to switch
operation modes and quit
Move up and move down
buttons
LED Display
59 mm
80 mm
59 m
m
80 m
m
10 mm 10 mm
31 mm
Back side
NTC
L L N N
AC Power input
Floor temp sensor
Output
Home Interface
SR-ZV9092A
Z-Wave Frequency
868.42MHz (EU)
Input Voltage
EU: AC200-240V, 50/60Hz
Output Voltage
EU: AC200-240V
Max Load
3680W @ 230V (resistive load)
Max Current
16A
Power Consumption
<2W
Ambient Temperature
0°C to 40°C (during operation)
Set Temperature Range
Hysteresis
0.5°C to 2°C (default 0.5°C)
Floor sensor type
Control Mode
OFF, HEAT, ENERGY HEAT
,
AWAY, DRY
Control Type
Wiring Requirement
IP Rating
IP21
Relative Humidity
8% to 80%
Dimensions
80x80x52mm
Approvals
0°C to 40°C
1. NTC/10K B(25/50 )=3950 (default)
2. NTC/15K B(25/50
℃
)=3950
3. NTC/50K B(25/50
℃
)=3950
4. NTC/100K B(25/50
℃
)=3950
℃
Control type means which temperature sensor the device refers to
when it adjust temperature.
Room sensor
: adjust temperature refers to room temperature
(factory default type).
Floor sensor
: adjust temperature refers to floor temperature.
Room+Floor sensor
: adjust temperature refers to both room
temperature and floor temperature.
Current
≤
13A - 1.5mm² solid core wire
Current > 13A to 16A - 2.5mm² solid core wire
Z-Wave Plus
,
CE
,
LVD
: EN 60730-1:2016;A1, EN IEC 60730-2-9:2019;A1
EMC & RF
: EN IEC 61000-3-2:2019, EN 61000-3-3:2013+A1:2019,
EN 60730-1:2016+A1:2019, EN 60730-2-
19:2019+A1:2019+A2:2020, EN 50663:2017;ETSI EN 301 489-
1V2.2.3, ETSI EN301 489-3V2.1.1
ETSI EN300 220-1 v3.1.1., ETSI EN300 220-2 V3.2.1
RED certificate
: 2014/53/EU
•
The Z-Wave HVAC controller is a wireless thermostat for heating system, which complies to Z-Wave Plus
wireless protocol standards. The thermostat has 4 operation modes which can be controlled manually and
locally or through remote controlled through Z-Wave primary controller (gateway).
Control Pollution Degree (Method D)
pollution degree 2
Rated Impulse Voltage (Method D)
4kV
