2. Remove the Torpedo Bottle from the cage by holding the mount and twisting the
bottle and pulling out.
4. Place the mount on the aerobars by placing each of the mounting
clamps onto the extensions. Ensure the clamp is secure and
completely touching the extensions.
3. Loosen the mounting clamp screws using the 3 mm Hex Wrench.
5. Center the mounting plate and hand tighten each of
the screws.
6. Secure the Velcro straps by routing them through the clamps.
Pull the straps as tight as possible and attach them in place.
7. Tighten both mounting clamp screws to 4.0 Nm (35 in-lbs).
TOOLS REQUIRED
MOUNTING TO BIKE
3 mm Hex Wrench
Torque Wrench up to 4.0 Nm (35 in-lbs)
HARDWARE
CAGE MOUNTING
M5 x 12 mm
Socket Head
M5 x 16 mm
Socket Head
M5 Flat Washer
(x2)
M5 Nylon Insert
Lock Nut (x2)
M5 Nylon Spacer
M4 x 20 mm
Flat Head Screw
M5 x 12 mm Button Head
Flange Screw (x2)
MOUNTING CLAMP
BOTTLE
M4 x 10 mm
Button Head Screw
(x2)
M3 x 6 mm
Flat Head Screw
(x2)
Screw Post / Screw
Spring
M5 x 25 mm
Flat Head Screw
IMPORTANT:
PLEASE COMPLETELY UNDERSTAND ALL USER INSTRUCTIONS AND SAFETY INFORMATION BEFORE USING THIS PRODUCT. AS WITH ANY HIGH TECH PRODUCT YOU WILL NEED TO
ROUTINELY CHECK FOR LOOSE HARDWARE, CRACKS OR OTHER DAMAGE AND REPLACE ITEMS AS NECESSARY. DO NOT USE PRODUCT IF ANY OF THESE CONDITIONS EXIST.
COMPUTER MOUNT
TORPEDO VERSA 200
TORPEDO VERSA 200
1. Rotate the top of the computer mount all the way forward to allow room for the bottle.
Dolphin Breather Valve
CAGE HARDWARE
DIAGRAM
REAR OF CAGE
M5 NYLON
SPACER
M5 x 16 mm
SOCKET HEAD
M5 FLAT
WASHER
M5 FLAT
WASHER
M5 x 12 mm
SOCKET HEAD
