Quick Installation Guide for XR-300 Models
The Xirrus XR-320 is a 2x2 802.11ac indoor wall access point (AP) with two fixed-band radios: one at 5 GHz and
one at 2.4 GHz. It includes an Ethernet wall switch with four 10/100/1000 ports, one of which may supply power.
Preparation
Run a data uplink cable (Cat5e/Cat6) for the 1 Gigabit uplink port.
Supply power—typically via IEEE 802.3af/at Power over Ethernet (PoE) on the same cable as the data uplink.
The total PoE uplink cable length must be no more than 100 m, including all cable segments. The Array must
be connected to PoGE networks without routing cables to the outside plant.
If you supply 802.3at PoE power to the uplink port, you may use the XR-320’s LAN4-PoE switch port to
supply 802.3af power and data to another device.
Alternatively, you may supply your own local 48 VDC power adapter meeting these specifications—
Pass-through port—this simply provides an Ethernet pass-through connection (with or without POE) from the
back of the unit to a port on the side of the XR-320.
LAN ports—these four switch ports on the bottom of the XR-320 allow you to provide Ethernet connectivity to
other devices. LAN4-PoE supplies 802.3af PoE, if a 48 VDC power adapter is used (
Step 5
below), or if 802.3at
PoE power is supplied as described above.
Wall Installation
Figure 1
Locking
tab
XR-300 Series Access Points (APs) should be mounted on an inside wall.
1.
Remove the blank wall plate from the wall with a screwdriver.
2.
As shown in
Figure 1
, feed the Uplink (PoE) and Pass-through cables
through the opening in the supplied mounting bracket and secure the
bracket to the wall using the two screw holes previously occupied by
the blank wall plate. Ensure that the “UP” label is at the top, and that
the tab for the locking screw is on the left facing towards you.
Output Power
+48VDC
Nominal Load
Current
0.63A
Ripple and Noise
At 20Mhz, and output parallel with 0.1uF and
10uF capacitors to ground, temperature at 25
°
C,
at nominal input voltage
Connector
Jack Plug 55*2.5*11.5mm
Polarity
