1 of 2
Line of Sight | (800) 463-7731 | los.workriteergo.com
Assembled Line of Sight Chassis with Worksurface
A
Line of Sight Power Bar
Qty: 1
B
Power Bar Bracket
Qty: 2
C
#10-24 ×¾" Phillips Head
Machine Screw
Qty: 2
Required, Sold Separately
Parts Included
IMPORTANT NOTE:
All daisy-chained Power Bar Systems
must be connected to only one 120 V, 60 HZ, 20 A power entry.
Do not exceed four Power Bars per dedicated power in. The user
is responsible for calculating and managing total power load.
Failure to follow these warnings may overload the system and
cause circuit breaker protection to shut down the power system.
Assembly Instructions: Line of Sight Power Bar
LOS3-MM024-4-6
D
#10-¾" Phillips Pan Head
Sheet Metal Screws
Qty: 2
✓
Verify That You Have All The Tools Needed For The Assembly
You will need the following tools:
Drill/driver or Phillips screwdriver with #2 tip
3/8" open ended wrench
1
Remove Front, Rear Panels & Grommet Cover
1.1 If not already removed, remove the Front and
Rear Panels by turning the Panel Locks a quarter
turn towards the center of the panel (inward),
then pivot the panels forward to remove.
If you have Locking Panels, unlock using the
included key.
1.2 Remove the Side or Rear Grommet Covers to
route power in the desired direction.
2
Attach Brackets to Power Bar
Attach the two Power Bar Brackets (B) to the back of the
Power Bar (A) using the two #10-24 ×¾" Phillips Head
Machine Screws (C).
ELECTRICAL RATING:
Power Bar electrical rating: model:
SA-MM024-4-6
15 A, 125 V per circuit
8 outlet, 6' cord
A
C
B
1.1
1.1
1.2
C
#10-24 ×¾" Phillips
Head Machine Screw
Hardware at actual size
Front
Panel
Panel
Lock
Rear
Panel
