AKT 466
PRODUCT DESCRIPTION SHEET
GB
5019 319 01500
To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation.
GR
IT
PT
ES
GB
LIGHTING THE BURNERS
•
To ignite one of the burners, turn the relative knob anti-clockwise to the maximum flame setting
.
•
Press the knob against the control panel to ignite the burner.
•
After the burner has ignited, keep the knob pressed for about 5 seconds to allow the thermocouple to warm up.
This burner safety device shuts off the gas supply to the burner if the flame goes out accidentally (because of sudden
draught, an interruption in the gas delivery, boiling over of liquids, etc.).
•
The device must not be pressed for more than 15 sec. If, after that time has elapsed, the burner does not
remain lit, wait at least one minute before trying to light it again.
-
The burner might go out when the knob is released. This means that the thermocouple has not warmed up enough.
In this case, repeat the operations described above.
PRATICAL ADVICE FOR USING THE BURNERS
For better burner performance, please stick to the following rules:
-
Use pots and pans that fit the burners (see table on the
right).
-
Only use flat-bottomed pots and pans.
-
Use the correct amount of water for cooking foods and
keep the pot covered.
-
In the case of pans with convex bottoms (WOK), use
the support grille provided, which should be positioned
only on the 4 ring burner.
Important:
Improper use of the grids can result in damage to the hob:
do not position the grids upside down or slide them across
the hob.
Do not use:
-
Cast iron griddles, ollar stones, terracotta pots and
pans.
-
Heat diffusers such as metal mesh, or any other types.
-
Two burners simultaneously for one receptacle (e.g. fish
kettle)
1.
Removable panstand grids
2.
Auxiliary burner
3.
Semi-rapid burner
4.
Semi-rapid burner
5.
4 ring burner
6.
Auxiliary burner control knob
7.
Semi-rapid burner control knob
8.
Semi-rapid burner control knob
9.
4 ring burner control knob
SYMBOLS
Tap closed
Maximum flame
Minimum flame
Burner
Pot Ø
4 ring burner
from 24 to 26 cm
semi-rapid
from 16 to 22 cm
auxiliary
from 8 to 14 cm
DIMENSIONS AND DISTANCES TO BE MAINTAINED (mm)
NOTE:
If the distance “A” between the wall cabinets is between 600 mm and 730 mm, the height
“B” must be a minimum of 530 mm.
If the distance “A” between the wall cabinets is greater than the width of the cooktop, the
height “B” must be a minimum of 400 mm.
In case of installation of a hood above the cooktop, please refer to the hood instructions for
the correct distance.
INJECTOR TABLE
CATEGORY
II
2H3+
ELECTRIC SUPPLY: 230 V ~ 50 Hz
Type of gas used
Type of burner
Injector
marking
Rated
thermal flow
rate kW
Rated
consumption
Reduced
heat capacity
kW
Gas pressure (mbar)
min.
rat.
max.
NATURAL GAS
(Methane)
G20
4 ring burner
Semi-rapid burner
Auxiliary burner
139
95
78
3.50
1.65
1.00
333 l/h
157 l/h
95 l/h
1.50
0.35
0.30
17
20
25
LIQUID
PETROLEUM GAS
(Butane)
G30
4 ring burner
Semi-rapid burner
Auxiliary burner
95
67
50
3.50
1.65
1.00
254 g/h
120 g/h
73 g/h
1.50
0.35
0.30
20
28-30
35
LIQUID
PETROLEUM GAS
(Propane)
G31
4 ring burner
Semi-rapid burner
Auxiliary burner
95
67
50
3.50
1.65
1.00
250 g/h
118 g/h
71 g/h
1.50
0.35
0.30
25
37
45
Type of gas used
Configuration
model
Rated thermal
flow rate kW
Total rated
consumption
Air necessary (m
3
) for the
combustion of 1 m
3
of gas
G20 20 mbar
4 burners
7.80
742 l/h
9.52
G30 28-30 mbar
4 burners
7.80
567 g/h
30.94
G31 37 mbar
4 burners
7.80
557 g/h
23.80
