159149H
© Copyright 2018 WESCO Industrial Products, LLC. Specifications subject to change. Not responsible for errors or omissions.
1500 Lb. POWER-LIFT STACKER
Operating Instructions and Parts Manual
ATTENTION:
To insure proper use of your WESCO Power-Lift Stacker, read these instructions thoroughly
before using. It is important that all personnel, involved with the installation, maintenance or operation of the
stacker, read this manual.
Specifications
See nameplate on unit for capacity, load center,
model number and truck serial number.
This product is manufactured by:
WESCO Industrial Products, LLC
1250 Welsh Road
North Wales, PA 19454
Tel: 215-699-7031 FAX: 215-699-3836
Contact the factory if you have start-up problems
after reading these instructions, or for parts infor-
mation and parts ordering. Visit us on the web at
www.wescomfg.com
Unpacking
When unpacking your unit, check carefully for ship-
ping damage. If damage has occurred, file a claim
with the delivering carrier within 24 hours and notify
the dealer from whom the unit was purchased.
Start-up
With the lift in the lowest position, check following:
1) Remove plastic cover by removing the four
hex bolts, two on the top and one on each side
(Fig.1). Then disconnect the switch and gage
at the plastic connector (Fig. 2).
2) Check for signs of damage, especially to the
back cabinet that houses the battery, electrical
/ hydraulic power pack.
3) Remove plastic pipe plug from oil reservoir,
screw in breather cap.
4) Connect negative (black) wire to negative
battery terminal and tighten.
5) Check all electrical connections for tightness.
6) Run unit up and down and check for any
hydraulic oil leaks.
7) Do not use the lift if there appears to be
any damage.
8) Reinstall plastic cover.
General Safety Information
WARNING:
WESCO Power-Lift Stackers are intended for
a wide range of uses. To insure proper use, the following
instructions must be adhered to:
1) Load Rating: The capacity of your unit is shown on a
metal tag attached to the truck. It is based on the load
center also shown on tag.
2) Do not use your unit for loads exceeding the size of
the platform or forks.
3) Never move unit unless the load is in the fully lowered
position.
4) Wesco power-lift stackers are intended for movement
of loads and lifting of loads to work position, not for
moving of loads in a raised position.
5) The floor lock is designed for minimizing movement of
unit during loading and unloading of items from the
units themselves. It is not to be used to control truck
speed when being moved. Be sure that lock is fully
engaged before loading and unloading.
6) Do not perform any repair work on lift if there is a load
on the forks or platform or if the forks or platform is in
the raised position.
7) All personnel must stand clear of the lift while lifting or
lowering platform or forks.
8) Do not stand, sit or climb on lift or use unit to lift
personnel.
9) Do not put hands or feet or stand underneath the forks
or platform when raised.
10) Do not use lift on uneven or unstable surfaces.
11) Custom alterations of units for specific functions not
made at the factory void all warranties without
exceptions. User made alterations may result in
unsafe conditions during use of unit.
WARNING:
The battery in this product can
expose you to chemicals including lead, which is
known to the State of California to cause cancer and birth
defects or other reproductive harm. For more information
go to www.P65Warnings.ca.gov.
Figure 1
Figure 2
