Step 1
Stand the WaterRower upright and disconnect the bungee from
the recoil belt.
Tools required:
2 x 5 mm Allen Keys (Hex / Inbus)
1 x 3 mm Allen Key
1 x Adjustable- spanner / wrench
Step 2
Lay the WaterRower down. Slowly pull the handle and let the
drive strap unwind from the clutch housing. Do this gently, as
pulling too fast may cause the recoil belt to wind up too much.
Disconnect the drive strap from the clutch using the 3 mm Allen
key. Pull the strap free of the clutch and remove the strap from
the rower completely.
Step 3
Remove the tie-rods (4x) using a 5 mm Allen key. Remove the
fasteners (4x) connecting the forward riser bottom bracket to
the side rails, using the two 5 mm Allen keys.
Tie-rods
Barrel-nut
Step 4
Take the forward riser out of the WaterRower and remove the
bottom bracket using an adjustable spanner / wrench. Lift one
of the wooden sides and remove the large pulley along with
the metal guide. Re-assemble the forward riser (with the two
small pulleys only) and mount the metal bracket in the correct
position. Mind the position of the hole. (This is a good point to
remove your old monitor, might you want to do so.)
Step 5
Reconnect the forward riser to the WaterRower with the lower
tie-rods (2x). Reassemble the fasteners (4x) connecting the
forward riser bottom bracket to the side rails. Align the barrel
Tie-rods
Barrel-nut
SMARTROW MOUNTING
INSTRUCTIONS
REVISED VERSION
WRM_7555
