![background image](http://html.mh-extra.com/html/walmart/wire-shelving-rack-c25b-1/wire-shelving-rack-c25b-1_assembly-instructions_870936001.webp)
3 Shelf Wire Shelving Rack
Vendor Stock# C25B-1 / C25Z-1
Assembly Instructions
Questions, Problems, Missing Parts?
Before returning to your retailer, CALL OUR CUSTOMER SERVICE DEPARTMENT at
1-866-375-7994, 9 a.m. - 5 p.m. EST. MONDAY- FRIDAY or E-Mail: [email protected]
PACKAGE CONTENTS
A - Shelf x 3
B -Top Pole x 4 C - Bottom Pole x 4 D - Plastic Tapered Lock x 24 + extra 2
E - Pole Cap x 4 F
–
Pole Connector x 4 G
–
Screw Pole Insert x 4 H
–
Feet Leveler x 4
Pre-installed on Pole (B) Pre-installed on Pole (B) Pre-installed on Pole (C) Pre-installed on Pole (C)
No tools required for assembly. Helpful - Rubber Mallet
Note: Black plastic discs between shelf collars are for packaging purposes only. They are NOT NEEDED. Discard upon assembly.
SPECIAL WARNINGS
Assemble the item on a soft, non-abrasive surface, such as carpeting, to avoid scratching the finish.
Use care when handling. May require two adults for safe assembly.
CARE AND MAINTENANCE
Periodically check and make sure that all components are in their proper position, are free from damage and that all connectors are tight.
ASSEMBLY INSTRUCTIONS Estimated Assembly Time: Approximately 15 minutes
1. Post Assembly
Screw the two post sections (B) & (C) together. Hands tighten.
Note: the top section has pole connector & cap. The bottom section has insert & feet leveler.
2.
Bottom Shelf Assembly
a. Locate the desired position of the bottom shelf. Note: Bottom shelf should be no more than six inches from the floor.
b. Insert two plastic tapered locks (D) in the appropriate pole groove, one set in each pole. Ensure tapered end is up (see arrow on lock).
c. Place shelf (A) on its side and slide each pole with tapered locks through the bottom of the shelf until snug.
d. After all poles are in place, position the unit in the upright position.
e. Push down on each corner of the shelf, ensuring the shelf is in a fully locked position.
3. Additional Shelf Assembly
a. Locate the desired position of the next lowest shelf (A) and insert the tapered locks (D) into the poles.
b. Slide the shelf down from the top of the poles and onto the tapered locks. Push down on each shelf corner, ensuring the shelf is in a fully
locked position.