![background image](http://html1.mh-extra.com/html/wac-lighting/fuego-eir3sf/fuego-eir3sf_installation-instructions_3102275001.webp)
INSTALLATION INSTRUCTIONS
FUEGO
MODEL
:
EIR3SF
WAC Lighting Headquarters WAC Lighting(Hongkong) WAC Lighting (Shanghai)
44 Harbor Park Drive Room A2 15/F United Center 14 Lane 299, Bi Sheng Road
Port Washington, NY 11050 95 Queensway HK, 999077 Shanghai 201204
www.waclighting.com www.waclighting.hk www.waclighting.com.cn
1
/
4
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
INSTALLATION STATEMENT:
1. Read all instructions before installing.
2. System is intended for installation by a qualified electrician.
3. To reduce the risk of fire, electrical shock and injuries to persons,
turn off power at main switch before installing or modifying the system.
4. In accordance with the National Electric Code and local regulations.
5. Suitable for both indoor and outdoor environment use.
6. Retain instructions for future maintenance reference.
FIXTURE ACCESSORY (included in box)
Hex Key Qty: 1pcs
CONCRETE POUR INSTALLATION:
1.
Install wiring and conduit (use 1/2” NPT) with Concrete Pour
Canister at desired position, plug all un-used holes (Fig. 1)
Secure the canister to the bottom of the application ground
by using screws. 1
)
Note: For proper alignment, make sure the flat edge of the
canister is parallel to the wall. (Fig. 2)
2. Insert Plastic Cap into Concrete Pour Canister (Fig. 1)
3.
Pour concrete until it’s flushed with the Plastic Cap. (Fig. 3)
NOTE: NO CONCRETE ENTERS THE BOX. USE SAND OR
GRAVEL FOR PROPER DRAINAGE.
4. After concrete has cured, crack concrete and remove Plastic
Cap using a corkscrew or similar tool. (Fig. 4)
5. Connect fixture leads to box wiring using supplied outdoor
Rated wire nuts. Make sure all power is off while wiring LED
fixture.
6.
Apply a smear of plumber’s silicone to O-rings. Insert LED
fixture into flange with a twisting motion. Make sure the trim
is flushed with the top of the poured concrete.
7. To match different height requirements, use extenders and
cover plates. (Fig. 5)