1.0 SPECIFICATIONS:
Input:
120 VAC, .2 amperes, 50/60 Hz
Output:
9VDC, .3 amperes, regulated output protected with foldback current limiting
Enclosure:
10” high x 10” wide x 4” deep hinged cover box, six (6) 1/2” knockouts total
on sides and back, (optional keylock available)
Battery Backup:
Backup time - 12 hours at .3A (or 2 ALKs in alarm)
Battery - one (1) 1.2AH or 1.3AH lead acid battery
Temperature:
0º to 120º F
2.0 MOUNTING:
For proper ventilation, power supply must be mounted upright in an area which allows free air circulation.
Mount with appropriate hardware (screws or bolts) through each of the four (4) mounting holes in the rear
of the enclosure.
3.0 WIRING:
(refer to
FIGURE 1)
3.1
Ensure AC breaker is open before connecting AC power to the power supply.
3.2
For all supply connections, use wires suitable for at least 90º C (194º F) temperature.
3.3
Input conductors must be segregated from the output conductors, they must not intermingle.
3.4
Connect the load to the
DC OUTPUT
terminals
+
(positive) and
-
(negative).
3.5
Connect AC input to the AC input wires using insulated connectors.
Secure the field ground conductor under the chassis ground nut.
3.6
Close breaker to turn on the power supply, the red
POWER ON LED
should be illuminated.
INSTALLATION INSTRUCTIONS
PS9 SERIES POWER SUPPLY
941062_00(1) Page 1 of 2
This supply cannot be
used to operate Von
Duprin EL or CX exit
devices.
Note:
*
CAUTION - Connect only to
circuits protected by a 20 amp
or less fuse breaker
CA
CA
CA
CA
CAUTION
UTION
UTION
UTION
UTION
!
DANGER - High Voltage
present on AC input
D
D
D
D
DANGER
ANGER
ANGER
ANGER
ANGER
!
Copyright © 2003 Ingersoll-Rand. All rights reserved.
