© 2017
Order #XXXXX
MOD-1182 Workstation
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at
Completed Assembly
Item
1
2
3
4
5
Qty.
1
1
1
4
2
Description
Base Plate
42.5” Q914 Vertical Extrusion
42.5” Q914 Vertical Extrusion
38.5” RSG510 Angled Extrusion
18” Z31 Horizontal Extrusion
Steps:
1) Attach vertical [2] to vertical [3], using connector. See
Vertical Extrusion Connector
detail.
2) Attach mount plates to angled verticals [4], using bolts.
3) Attach vertical assembly [1/2] and angled verticals [4] to base plate [1], using bolts.
4) Connect horizontals [5] between angled verticals [4].
5) Place shelves on top of horizontal [5], then secure with thumb screws into [2].
6) Attach counters to angled verticals [4]. then secure with thumb screws into [2].
See
Counter Attachment
detail.
7) Connect conduit to vertical [2] and route monitor cords. See
Cord Management
detail.
8) Attach monitor mounts to vertical [3]. See
Monitor Mount
detail.
9) Attach headers to vertical [3], using screw caps into V4’s.
1
2
4
4
5
5
3
Counter
Shelf
Shelf
Header
Screw
Cap
Mount
Plate
V4
V4
Monitor
Mount
Header
Counter
4
4
Set Screws
Connector
Vertical Extrusion Connector
Slide upper Extrusion
over Connector and
rest on lower Extrusion.
Secure with Set Screws.
*
To prevent product loss, Keep
all screws attached to Connector,
after disassembling.
Monitor Mount
V4 Connectors
*
Slide connectors into groove
of extrusion. Tighten set screws
to secure connectors in place.
Attach monitor mount back
plate to extrusion, using bolts.
Bolts
Monitor
Mount
Cord Management
Route cord through Conduit.
Attach Conduit by pinching
the opening and inserting
into the groove of Extrusion.
pinch
Cord
Conduit for cord management
* *
to Monitor
Mounts
to power
*
Counter Attachment
Wing
Nut
Mount
Plate
Counter
Insert screws, located on
underside of counter, into
holes on mount plate.
Secure with wing nuts.
5
5
2
3
3
