12 VOLT IN
12 VOLT IN
12 VOLT IN
12 VOLT IN----POOL LIGHT
POOL LIGHT
POOL LIGHT
POOL LIGHT
( Model OPT12V)
( Model OPT12V)
( Model OPT12V)
( Model OPT12V)
IMPORTANT SAFETY & INSTALLATION INFORMATION
•
This product meets or exceeds applicable standards established by Underwriters
Laboratories (UL listed) - see back page, Details 5.1 - 5.3
•
Install to / plug into only a 110V receptacle protected by a ground fault circuit
interrupter (GFCI). The GFCI should be enclosed and weatherproof and at least 1
foot above ground surface. Review your local code requirements before use
•
Always remove plug from receptacle before installing, winterizing or servicing light
•
DO NOT USE EXTENSION CORDS - DEATH OR INJURY CAN RESULT
•
This product is designed and intended for use as an underwater light in an above-
ground pool; never modify or use for any other purpose, serious injury can result
•
Light fixture MUST be submerged in water before plugging in / illuminating
1. Before starting installation of light, remove ladder or step from pool (if assembled / installed
already). Fit cord of light through light bracket, front to back (Detail 1.1 - 1.2). The bracket has two
small notches (Detail 1.3 - 1.4), the cord fits into a notch when pressing the light into the bracket.
Press light to fit into bracket completely; to the back of the bracket (Detail 1.5)
Detail 1.4
BACK
FRONT
Detail 1.1
Detail 1.2
NOTCH
NOTCH
Detail 1.3
Detail 1.5
2. Insert light & bracket into ladder or stair system. Both units have a molded hole that will require
to be trimmed out (Detail 1.1 - 1.2). With a utility knife, trim hole gentle around seam to remove
plastic center leaving a smooth edge. Insert light and bracket into the trimmed hole. Align holes in
bracket with screw marks in ladder or step (Detail 2.3). Drill a 1/8" hole and secure bracket & light in
place using the stainless screws provided (Detail 2.4). Make certain light is secure. Pass cord up
behind ladder or step, over pool top rail, and to GFI receptacle. Make sure cord is secure and neatly
tucked out of the way as not to interfere with traffic in or around the pool (Detail 2.5).
Detail 2.1
Detail 2.2
Detail 2.3
Detail 2.4
4. Insert light cord into transformer & thread
tight (Detail 4.1). The transformer plug MUST
be plugged into a 110V GFCI receptacle (see
above safety information). NEVER USE AN
EXTENSION CORD. The receptacle must be
enclosed & weatherproof & at least 1 foot
above ground surface
GFCI
Detail 4.1
LIGHT FIXTURE MUST BE SUBMERGED IN WATER
BEFORE PLUGGING INTO RECEPTACLE
1
3
4
2
3. Note proper place-
ment of light in steps.
The steps have four
risers; the light should
be placed in the second
riser down from the top.
Pivot light up or down if desired
2.5
