Installing inside the window frame…
At top and bottom of window frame measure at least 12mm in
from each end and 14mm back from front of window frame and
mark where the screws will go.
We recommend drilling pilot holes for the screws using a 2mm bit.
Fix the Shoe Bases into position using 1 long screw for each Shoe
ensuring the outer edge is to the outside of the window.
Installing outside the window frame…
We recommend using a spirit level for vertical and horizontal
alignment.
Place the blind in position and mark the top corners of the blind.
Measure 4mm down and 5mm in from the top left and top right of
where the blind will sit, and mark the location of the L bracket outer
screws (ensure screws are at least 16mm from window opening).
The measurement from this screw to the screw on the bottom brackets
is the ‘order height’ minus 8mm (order height can be found on the
outside of your box). And mark with a pencil.
Place L brackets in position and mark where the other screws will go.
We recommend drilling pilot holes for the screws using a 2mm bit.
Fix the L brackets into position using 2 long screws for each bracket.
Fix the Shoe Bases onto the L Brackets using 1 short bolt for each shoe,
ensuring the outer edge is to the outside of the window.
How to install your
Smartfit Day & Night Honeycomb Blind
(25mm Cell)
Included Hardware
measuring
tape
drill with
2mm bit
phillips bit or
screwdriver
pencil
knife
The hardware can be found in
the end of every box.
1
Installation Brackets
Wall Plugs for Brick
or Cement using
a 6mm bit
(if requested)
Required Tools
Shoe Base
(For Headrail and
Bottom Rail)
Installation
L Bracket
(Outside Install)
Handle
Short Bolt
Long Screws for
Wood
#65101-11520-A
Extension Pole
(if requested)
L Bracket Cover
(Outside Install)
Shoe Slider
(Attached to blind)
Inner Edge
Outer Edge
Difficulty:
★★☆☆☆
1
Attach the handle to the handle support pre-attached on the rail then slide against the handle
support to the left until the handle can’t move anymore.
2
Attach Handle
3
2
1
