![background image](http://html1.mh-extra.com/html/gimenez-ganga/saxun-plisada-glass-111/saxun-plisada-glass-111_assembly-and-installation-manual_2228284001.webp)
Assembly and installation manual
Plisada Glass
MK1146
· EN · 0
2 · 0522
Giménez Ganga, S.L.U.
Polígono Industrial El Castillo
C/ Roma, 4
03630 • Sax (Alicante) • España
saxun.com
EN
Place the frame in the window opening,
without removing
the protective adhesive tape.
Warnings
Product installation
Clean the marked areas of the window with alcohol.
Then, adjust the clips to be as close as possible to the corners.
General recommendations regarding safety, use
and restrictions
In order to ensure the safe assembly, use and maintenance of this product, a
number of precautionary measures must be taken. Please observe the following
warnings and instructions, for the safety of all concerned.
Please read this manual carefully
before starting work.
Some components may be sharp or
have jagged edges. It is therefore
advisable to wear safety gloves..
All parts supplied have been designed
specifically for this product. The re
-
placement or addition of other parts
may have a negative effect on the
safety of the product and its warranty.
Under no circumstances should a
damaged product be installed, as
it may damage the equipment and
create situations that are dangerous
for people.
These systems are exclusively inten-
ded for the use for which they were
designed. Any other use is inappro-
priate, and therefore dangerous.
The manufacturer will not be liable
for damage caused during the ins-
tallation due to non-compliance with
these recommendations.
1
2
1
2
3
1
1
1
1. Clean the window
2. Adjust the supports
Remove the protective adhesive tape.
Press each corner firmly against the
window for 5 seconds, starting with
the lower corners of the Stor
3. Install the product
Model 140
Model 111