Vantron
| Embedded in your success, Embedded in your better life
World-leading provider of embedded/IoT products and solutions
TMC series | Quick Installation Guide
Vantron TMC Series Desktop/Wall-mountable
Touchscreen Monitors
Quick Installation Guide
Version: 1.2
© Vantron Technology, Inc. All rights reserved.
General Safety Instructions
For your safety and prevention of damage to the Product, please read and observe carefully the following safety instructions prior to installation and operation. Keep this guide well
for future reference.
°
Do not disassemble or otherwise modify the Product. Such action may cause heat generation, ignition, electronic shock, or other damages including human injury, and may void
your warranty.
°
Keep away from heat source, such as heater, heat dissipater, or engine casing.
°
Do not insert foreign materials into the openings of the Product as it may cause the Product to malfunction or burn out.
°
Use only the adapter and power cord that are approved for use with this Product. Otherwise, it may cause fire or explosion.
°
Be sure that nothing rests on the power cable and that the cable is located at a place without risk of trips.
°
Cut off the power before inspection of the Product to avoid human injury or product damage.
°
It is recommended to avoid leaving static images on the screen for extended periods of time, as this may lead to temporary image retention or "burn-in". For best practices, you
are advised to use screen savers or power-saving settings while not operating the device for an extended period.
ESD Precautions
While setting up an electronic system or handling electronic components, certain precautions and proper handling procedures should be followed to prevent ESD-induced failures.
Careless handling of ESDS components can degrade their reliability and life expectancy.
Electrostatic discharge (ESD) events can harm electronic components inside the Product. Under certain conditions, ESD may build up on your body or an object, such as a peripheral,
and then discharge into another object, such as the Product. To prevent ESD damage, you should discharge static electricity from your body before you interact with any of the
Product’s internal electronic components.
You can protect against ESD and discharge static electricity from your body by touching a metal grounded before you interact with anything electronic component on the Product.
When connecting a peripheral to the Product, you should always ground both yourself and the peripheral before connecting it to the Product. In addition, as you open the Product for
maintenance, periodically touch a metal-grounded object to remove any static charge your body may have accumulated.
Disclaimer
While all information contained herein has been carefully checked to assure its accuracy in technical details and typography, Vantron does not assume any responsibility resulting
from any error or features of this manual, nor from improper uses of this manual or the software.
It is our practice to change part numbers when published ratings or features are changed, or when significant construction changes are made. However, some specifications of the
Product may be changed without notice.
Please refer to the
user manual
of this series for more information on safety cautions and regulatory compliance statements.
Vantron Technology, Inc.
Address: 48434 Milmont Drive, Fremont, CA 94538
Tel: (650) 422-3128
Email:
