Step
3
TM
Quick Start Guide
What’s in the box?
Kanega LTE Watch, Charger, Power Cable, Four Batteries, Quick Start
Videos and downloadable User Guide at www.unaliwear.com/support.
Charge your Kanega batteries before inserting on the watch.
1. Connect the power cable to one end of the charger and plug
into wall. Verify green light on charger jack is on.
2. Insert two (2) batteries into ports by placing the top end with the
gold prongs first, and then pressing the bottom of the battery
gently downwards until you hear or feel it attach into place.
3. Battery light fades red when batteries are charging and turns green
when they are charged. Charging time may take up to 4 hours.
Step
1
Install fully-charged Kanega batteries on the watch.
1. To insert a battery, place the top end with the gold prongs first,
and then press the bottom of the battery gently
downwards until you hear or feel it attach into place.
2. Place a charged battery on both sides of the
watchband and put the remaining two batteries on
the charger so they are ready when needed.
3. You will see a black/blank screen. After batteries are
installed for the first time, the display changes to ‘Kanega Watch’ with
moving dots. If you do not see this within 5 seconds, press the crown
button once.
4. Initial set up may take up to ten (10) minutes.
5. The display changes to ‘Press crown to begin’ when the watch is
ready for you to listen to the short tutorial
Listen to welcome voice tutorial through the Kanega watch
speaker.
1. One short press of the crown button starts the 5 minute voice
tutorial. There is one (1) minute to begin before the watch goes to
sleep and returns to black/blank screen.
2. Please wear your Kanega watch during the voice tutorial.
Step
2
UnaliWear Customer Success [email protected] 1-888-343-1513, ext. 1
TOP
BOTTOM
TOP
BOTTOM
Thank you for purchasing the Kanega watch. Refer to the User Guide for details.
PORT
JACK
BATTERY
