1011 IH-841U-20
PAGE 1 OF 3
PARTS
ASSEMBLY
Step Ladder
Notched Bushing (4)
Handrail Bracket (2)
(shipped attached
to side of stile)
F. Back Panel (1)
C. Rear Handrail Bar (1)
(shipped under a step
attached with orange ties)
9
⁄
16
" Wrench or Socket (2)
7
⁄
16
" Wrench or Socket
TOOLS NEEdEd
WARNING! Assembly of these types of ladders
can be inherently dangerous. Please take all
necessary precautions during the assembly
process. Always use a separate ladder to
finish assembly in high places. Never climb a
ladder that is not completely assembled. Do
not assemble or use a ladder with missing or
damaged parts. Use proper lifting mechanics
when assembling a ladder. Watch for overhead
electrical hazards and obstructions.
STEP 1: FRAME ASSEMBLy
NOTE: DO NOT tighten bolts until instructed to.
NOTE: Back panel (F) has both round and
slotted holes. The round holes are at the bottom,
and the slotted holes are at the top (L1).
1. Place the ladder stile (d) on the floor. Be sure to
assemble on a protective surface so the finish does
not get damaged. (See Figure 1)
Rubber Mallet
Safety Glasses
5-7 STEP ROLLING
SAFETY LADDERS
20" AND 30" DEEP TOP STEP
A. Handrail (1)
B. Handrail (1) Opposite
Hardware Kit (1)
(misc. hardware included)
G. Base Panel (1)
d. Stile (1)
H-841U-20, H-841U-30
H-1083U-20, H-1083U-30
H-843U-20, H-843U-30
E. Handrail
Extension Panel (2)
Extension Clamps Set (4)
I. diagonal Brace (2)
(used only on 30" deep top ladders)
