background image

PAGE 1 OF 9 

0621 IH-6509

H-6509, H-6510

HARD-WIRED EXIT SIGN

1-800-295-5510

uline.com

SAFETY

CAUTION! When using electrical equipment, 
always follow basic safety precautions, including:

• Do not use outdoors.
• Do not mount near gas or electric heaters.
• Do not let power cords touch hot surfaces.
•  Use caution when servicing batteries to avoid 

possible shorting.

•  Mount in locations and at heights where it 

will not readily be subjected to tampering by 
unauthorized personnel.

•  Use of accessories not recommended by the 

manufacturer may cause an unsafe condition.

•  Do not use this equipment for anything other 

than intended use.

•  Before wiring to AC service, turn off AC power 

at fuse or circuit breaker.

•  Disconnect AC power and unplug battery 

before servicing.

•  Only use specified lamps in the fixture.
•  Battery in unit may not be fully charged. After 

AC service is supplied to unit, let battery charge 

for at least 24 hours before performing any tests.

CAUTION: Halogen cycle lamps are used in 

this equipment. To avoid shattering: Do not 
operate lamp in excess of rated voltage.

•  Protect lamp against abrasion and scratches 

and against liquids when lamp is operating, 
dispose of lamp with care.

•  Halogen cycle lamps operate at high 

temperatures. Do not store or place 
flammable materials near lamp.

TOOLS NEEDED

Phillips Screwdriver

Flathead Screwdriver

BACK MOUNTING

1.  Drill 1/4" holes into oblong knock outs on back plate 

that correspond to junction box holes to be used. 

(See Figure 1)

2.  Feed transformer input leads through center hole 

and make the proper connections. (See Figures 2-3) 

NOTE: If using 120VAC, connect black and white 

leads to building utility.

NOTE: If using 277VAC, connect orange and 
white leads to building utility.

If the unit is self-powered, be sure to snap battery 

connector together.

INSTALLATION

Figure 1

Wire Nuts

Back Plate

EXIT Panel

Diffuser

Junction

Box

Plastic

Housing

Snap-in

Directional Arrow

120VAC

277VAC

Connect black and white 

leads to building utility.

Connect orange and white 

leads to building utility.

Cap Unused 

Orange Wire

Figure 2

Cap Unused 

Black Wire

Figure 3

Para Español, vea páginas 4-6.

Pour le français, consulter les pages 7-9.

Summary of Contents for H-6509










Reviews: