PAGE 1 OF 6
1120 IH-1256
FOOT OPERATED SEALER
WITH CUTTER
1-800-295-5510
uline.com
H-1256, H-1257
Insert stand into foot pedal
base. From front, screw stand
tight with two short screws using
1/2
"
socket wrench.
(See Figure 1)
NOTE: Do not insert
screws into stand. Use
screws in foot pedal
base.
TO ATTACH SEALING HEAD
1. Place head on top of stand.
2. Align large hole on sealing head base bracket with
screw holes on stand, and screw sealing head to top
of stand. Angle sealing head to proper position and
secure with sealing head angle knobs on both sides
of bracket.
TO ATTACH ROLL BRACKET
1. Fit roll bracket onto stand and place small roll
bracket plate on opposite side of stand.
2. Align four screw holes on small roll bracket plate and
roll bracket.
3. Screw tightly to secure roll bracket on stand using
Phillips screwdriver.
4. To adjust height of roll bracket on stand, loosen four
screws and slide bracket up or down as needed.
TO ATTACH FOOT PEDAL ROD
1. Place hook of rod through
pull screw. (See Figure 2)
2. Drop T-shaped end through
open slit of foot pedal and
twist to lock in small notches
on underside of foot pedal.
(See Figure 3)
3. To adjust length of foot
pedal rod, detach bottom
of rod from foot pedal, then
screw bottom half of rod up
or down as needed.
(See Figure 4)
ASSEMBLY
Para Español, vea página 2.
Pour le français, consulter la page 3.
Figure 2
Figure 3
Foot Pedal
Figure 4
TOOLS NEEDED
1/2" Socket Wrench
Phillips Screwdriver
Figure 1
Stand
