![background image](http://html.mh-extra.com/html/u-line/h-10029/h-10029_manual_829642001.webp)
PAGE 1 OF 18
0422 IH-10029
H-10029
INDUSTRIAL
DEHUMIDIFIER
1-800-295-5510
uline.com
SAFETY
INSTALLATION
WARNING! This unit has an electric shock
hazard, rotating fan and hot surface hazards.
Unplug unit before opening cover for cleaning
or servicing. Unit must be grounded.
• Inspect the power cord before use. If cord is
damaged, do not use. Always grasp the plug
(not the cord) to unplug.
• Insert three-prong plug on power cord into a
matching electrically grounded outlet. Do not
use adapter. Never cut off third prong. Do not
use an extension cord.
• It is recommended to operate unit on a
115V/60 Hz circuit protected by a Ground Fault
Circuit Interrupter (GFCI) device.
• Keep motor and wiring dry.
• Do not attempt to repair the unit. Contact
Uline Customer Service at 1-800-295-5510 for
assistance.
NOTE: Unit is shipped without the handle
attached. Install handle using the four 1/4-20
hex head bolts supplied and a 3/8" wrench.
Ensure bolts are firmly secured before using
unit.
NOTE: Unit operates by pulling moist air in
across a cold evaporator core. The moisture
in the air condenses on the coil. In certain
conditions, the machine operates in defrost
mode, warming any frost accumulated on
the evaporator coil back into water. The water
collects in a tray and is pumped out through
a hose.
IMPORTANT! Before moving the unit, ensure no
water is in the pump.
NOTE: Operate in an enclosed area, as this
creates a drying chamber. Close all doors and
windows that open to the outside to maximize
the unit's water removal efficiency. Keep
traffic through the drying room to a minimum.
Place dehumidifier against a wall, away from
obstructions, and keep it away from anything
that could block airflow into and out of the unit.
NOTE: Optimal drying temperatures range from
68-85°F.
Para Español, vea páginas 7-12.
Pour le français, consulter les pages 13-18.