Covers Part #6591
Pro Scale
®
Advanced Lighting Control System Installation Instructions
Kit Contents:
• Pro Scale Lighting Power Module
• Power module chassis mount
• Pro Scale Lighting Distribution Block
• Motor sense wire harness
• Breakaway cable (part of the distribution block)
• MAXX® Link cable (Data Link)
(TQi Radio System only)
• Receiver communication cable
• 2.6x8mm button-head cap screw (2)
• 2.5x10mm countersunk cap screw (1)
• 2.5x12mm cap screw (1)
• 2.5x18mm cap screw (1)
• Zip ties (10)
• Silicone grease
TRAXXAS.com
Traxxas, 6250 Traxxas Way, McKinney, TX 75070, Phone: 972-549-3000, Fax: 972-549-3011, e-mail: [email protected]
HKC20008-R02 Rev 201203
Letter Description
Function
A
Reverse light harness
Back up light LEDs when vehicle is put in reverse
B
Rear turn signal harness
Rear turn signal LEDs (if equipped)
C
Tail light harness
Tail lights, brake lights, and rear integrated turn signal LEDs
(if equipped)
D
Rear side marker harness
Rear side marker LEDs (if equipped)
E
Rear independent turn signal jumper
Install jumper when using rear independent turn signals
(separate amber LEDs); remove jumper when using rear
integrated turn signals (single red LED for tail, stop, and turn)
F
Rear integrated turn signal jumper
Install jumper when using rear integrated turn signals (single
red LED for tail, stop, and turn). Remove jumper when using
rear independent turn signals (separate amber LEDs)
G
Head light assembly harness
Headlights, front marker light LEDs, and side marker light LEDs
H
Front turn signal harness
Front turn signal light LEDs
K
Rear high brake light harness
High brake light LEDs (if equipped)
M
Light bar high/low harness
LED light bar that typically mounts to the roof of the vehicle
(if equipped)
N
Rock lights/scene lights assembly
harness
Accessory LED lighting that mounts to the vehicle body
(if equipped)
Each TRX-4® and TRX-6™ model has its own unique LED light kit package (lights and wiring) and
Pro Scale Lighting Installation Kit
(listed below, each sold
separately). The included instructions cover installation of the mounting system and a wiring diagram specific to the model. If you have already installed a
Traxxas LED light kit on your TRX-4 or TRX-6 model, the installed lights are compatible with the
Pro Scale Advanced Lighting Control System
, except for
the Land Rover® Defender®, which requires a new LED light kit with additional lighting positions.
Visit Traxxas.com/ProScaleLighting for additional information.
The
Traxxas
Pro Scale® Advanced Lighting Control System
consists of two major electronic components: the
Pro Scale Lighting Power Module (LPM)
and the
Pro Scale Lighting Distribution Block (LDB)
. The
LPM
installs on the chassis of the vehicle and performs as the voltage regulator and power
supply for the lighting system. It also controls various lighting functions through the two buttons on the face of the module and communicates with
the receiver in the model via the communication cable (or the optional included MAXX® Link cable for models equipped with a TQi radio system). The
LDB
mounts in the body of the vehicle and is the distribution hub for all the various wired lights in the body. Its main function is to direct power and
instructions to each of the installed lights to operate features such as brake lights, tail lights, reverse lights, turn signals, and high/low beam lighting.
There is only one rugged breakaway wiring connector between the
LDB
and the
LPM
for reliable lighting performance, plus it makes it easy to remove
the body for vehicle service. The connector is designed to break away from the vehicle, without damage, if the body comes off the vehicle in a crash.
There are lighting channels on the
LPM
which allow lighting installed on the chassis to be permanently connected and integrated into the system. This is
helpful to install features such as rock lights, bumper lights, and other chassis-mounted accessory lighting.
Tools required:
• 2.0mm hex wrench (part #3415, sold separately)
• Wire cutters (to trim zip ties)
• Small needle nose pliers
AUX
POW
ER
IN
RX IN
OUT
Part 6592
1
2
3
4
5
6
7
8
9
10
11
12
MOTOR
SENSOR
MAXX LINK
SIGNAL
MODE
PRO SCALE
®
LIGHTING POWER MODULE
Mode Select
(see table in
Operation section)
Signal Select
(see table in
Operation section)
Breakaway Cable
Connector Port
(connects Power Module
to Distribution Block)
to Traxxas XL-5 HV Electronic
Speed Control (ESC) or direct
battery power source
up to 3s LiPo or 12.6V
Receiver Communication Cable Port
(connects power module to receiver
using receiver communication cable)
Motor Sense
Connector Port
Auxiliary Power Connector
(3V - always on)
POWER MODULE
Top View
Side Views
MAXX® Link Cable Ports
(connects power module to
receiver using MAXX Link cable)
(TQi Radio System only)
Visitez Traxxas.com/manuals pour télécharger
les instructions dans votre langue.
Visite la página Traxxas.com/manuals para
descargar el instrucciones en su idioma.
Auf Traxxas.com/manuals, können Sie
anleitung in Ihrer Sprache downloaden.
Model Fitment
TRX-4 Sport
TRX-4 Sport
Equipped with Traxx™
Mercedes-Benz®
G 500®
Mercedes-Benz®
G 63®
Land Rover®
Defender®
Ford® Bronco®
1979 Chevrolet®
Blazer®
1969 & 1972 Chevrolet®
Blazer® Body
Vehicle
Model Number
82024-4
82034-4
82096-4
88096-4
82056-4
82046-4
82076-4
9111X
9112X
Installation Kit
Part Number*
8083**
8083**
8893**
8893**
Included with 8095
LED Light Kit
8032**
8082**
8091
Compatible
LED Light Kit(s)
Part Number*
8085, 8086,
8087, 8088
LED Light Kit
factory installed
8899
LED Light Kit
factory installed
8095
†
8036
8039
8090
*All LED light kits and installation kits sold separately. Install LED lights kit(s) prior to installation of the Pro Scale Advanced Lighting Control System.
**Includes additional amber and/or reverse lights (as required by model).
†Includes additional amber, fog, and reverse lights. LED Light Kit 8030 for Land Rover® Defender® is not compatible with the Pro Scale Lighting Power Module.
PRO-SCALE
DISTRIBUTION
BLOCK
#XXXX
™
E
F
G
H
K
M
N
A
B
C
D
Part 6593
PRO SCALE
®
LIGHTING
DISTRIBUTION BLOCK
DISTRIBUTION BLOCK
LED LIGHT HARNESS PORTS
Wiring connectors for the lights are labeled
with numbers and/or colors.
