How to install the Immobilizer
T22-IMMOBILIZERMAN 2.5
© Tramigo Ltd. All rights reserved. Under the copyright laws, this manual cannot be reproduced in any form
without the prior written permission of Tramigo.
Page 1
This installation guidance is for the Tramigo T22-IMMOBILIZER12 and T22-IMMOBILIZER24.
The Immobilizer feature is used to disable a car’s ignition. This option requires special wiring
that must be done carefully to ensure trouble-free operation. With this feature active a car will
not start even if the T22 is removed.
IMPORTANT NOTICE:
This is an examplatory installation scheme only. Variation may be required depending to the type of vehicle
or machine to which T22 will be installed. All possible direct and indirect damages caused by the installation
are the sole responsibility of the installer or installing body. The installer or installing body is responsible to
test and ensure the functionality of their installation. All possible direct and indirect damages caused by the
use of the immobilizer are the sole responsibility of the end user. Tramigo Ltd’s manufacturer responsibility
is limited to the function of Tramigo T22 unit as stated in the warranty clause that can be found from the User
Manual and is not extended in any way for the installation done by a third party.
The installation should always be done only by professional mechanics, which have been properly trained to
install or service the Immobilizer. We recommend that you do NOT install the Immobilizer yourself, unless
you are a professional mechanic and knowledgeable about the Immobilizer.
The installer or installing body is responsible that the installation complies with local legislation. Additionally
if the Immobilizer is to be installed to a vehicle the installer, Installing body and the end user are responsible
to check the local legislation regarding the execution of the immobilization command and comply with the
regulations. Extreme caution must always be used if the immobilization command is executed on a moving
vehicle. SMS can take a while to be received, so the vehicle may be in a dangerous location or travelling at a
high speed when the immobilizer is activated. Vehicle’s engine will be shut down, power steering will be lost
and the vehicle will be difficult to control.
The disable command is used to activate the immobilizer. Disable,on prevents the engine from
starting. This will occur immediately if the vehicle is parked or 45 seconds after the ignition has
been turned off, and vehicle is not in moving state. Disable,off allows the engine to start. You
must have SMS coverage to be able to use these commands. Disable,on,forced shall
immobilize the vehicle regardless of the vehicle state. Please use this command with extra
caution.
This feature is supported by firmware v1.54 or higher and T22i
Command:
Disable,on
- immobilizer will engage only when it meets conditions
Disable,on,forced
- immobilize the vehicle as soon as T22 receives the SMS.
Disable,off
- immobilizer has been turned off and vehicle may function again.
Vehicle must have GSM coverage for these commands to work.
