0GU5085, V.01
AirBath Remote Synchronization Instruction
Remove and restore power
This can be done by unplugging the blower/controller and re-connecting it. This can also be
done by switching off the circuit breaker and switching it on again.
NOTE: Using the On/Off button on the remote will not accomplish this step.
1
Remote
ON/OFF
INCREASE
BLOWER
DECREASE
BLOWER
MODE
LED
When is synchronization needed?
It is possible that the remote has lost synchronization when it does not respond properly.
Synchronization is needed when the remote is replaced or when the blower/controller is re-
placed.
Press and hold increase blower and decrease blower
The increase blower and decrease blower buttons need to be pressed simultaneously and held
down for 4 seconds.
NOTE: This must be done within 15 seconds after restoring power.
2
Repeat steps 1 and 2 if needed
After steps 1 and 2 are complete the remote should work correctly. If not repeat the steps.
3
