Form No. 3360-101 Rev A
Zero Turn Radius Mowers
All models
Setup Instructions
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
Deflector assembly
1
Rod
1
Spring
1
7
Cotter pin
1
Install the discharge deflector.
Side discharge baffle
1
Carriage bolt (5/16 x 3/4 inch)
2
Hex-head bolt (5/16 x 3/4 inch)
2
Lock nut (5/16 inch)
4
8
Hole cover decal
3
Convert to side discharge (optional).
Ignition Key
1
Hose coupling
1
Operator’s Manual
1
Engine Operator’s Manual
1
9
Operator Training Material
1
Complete the setup.
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Checking Tire Pressure
No Parts Required
Procedure
1. Check the tire pressure in the drive tires. Proper
inflation for drive tires is 13 psi (90 kPa).
2. Adjust if necessary.
2
Fastening the Seat
No Parts Required
Procedure
1. Remove the nut and bolt from the loose end of the
lanyard.
2. Tilt seat downward and align lanyard to the hole in
the side of the seat (see Figure 1).
3. Install bolt and nut. Tighten bolt and then loosen
nut 1/4-1/2 turn so that lanyard end rotates freely.
Verify that lanyard is free to rotate on both ends so
that it pulls straight while supporting the seat..
Printed in the USA.
Original Instructions (EN)
All Rights Reserved
