Toro 110-5076, Installation Instructions

Page: 1 / 4

Form No. 3354-831 Rev A
Footswitch Upgrade Kit
For Multi-Pro 5600 Turf Sprayer
Model No. 110-5076
Installation Instructions
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step Description Qty. Use
1
No parts required
–
Prepare the machine.
2
No parts required
–
Remove the foot switch.
Floor switch 1
Wiring harness 1
Hex-head screw (1/4 inch)
2
Lock washer (1/4 inch) 2
Nut (1/4 inch) 2
3
Wire tie 4
Install the oor switch.
Step
1
Preparing the Machine
No Parts Required
Procedure
1. Park the sprayer on a flat surface, lower the
booms, set the parking brake, stop the engine,
and remove the key.
2. Disconnect battery negative cable.
Step
2
Removing the Foot Switch
No Parts Required
Procedure
1. Disconnect Sprayer Foot Switch connector
under floor pan.
2. Remove the retaining nut and remove the
sprayer foot switch from the floor pan. Discard
the foot switch.
3. Remove the bolt securing the left side of
the front hood to the floor pan to allow the
existing floor switch wiring to be brought
above the floor pan (Figure 1).
© 2005—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com. Original Instructions (EN)
Printed in the USA.
All Rights Reserved