INSTRUCTION MANUAL for Sanders and Polishers
For our model:
NCNA113 SANDER
WARNING!! DO NOT DISCARD – BUT GIVE TO USER WARNING!!
Air supply requirements
Supply tool with 6.0 bar of clean, dry air. Higher pressure drastically reduces tool life
and/or can cause severe injury.
Connect tool to air line using pipe, hose and fitting sizes shown in the diagram above.
Do not install a quick coupler directly into the air tool throttle handle.
In order to have the tool working to full satisfaction the minimum air delivery must be at
least 10% higher than the indicated air consumption of they air tool.
Please consult the technical data in this instruction manual
.
Operation
To apply sanding strip, raise each lever on the end of sanding shoe. Place one end of
paper under clamp and lock lever.
Pull paper firmly over sanding shoe and secure clamp.
The free speed can be adjusted by means of the handle or the regulator (L – H).
If an extra support handle is supplied with the tool that it be fitted before the tool is used
and hold, if possible, the tool with two hands.
