background image

HANDY, DIVISION OF JANCO INDUSTRIES INC. 

600 West 2

nd

 Ave. Sully, IA 50251 – Ph: 855-752-5446 – www.handyindustries.com 

 DECK HAND  

 

P/N 21660

 

-INSTRUCTIONS    -PARTS DRAWING   - PARTS LIST 

 
 
 

 

 

 
 
 
 
 
 

 

 

 
 

HANDY LIMITED WARRANTY 

  

 

Handy, Division of Janco Industries, Inc. warrants to the original purchaser of this product, all parts to be free from defects 
in manufacture for a period of one (1) year from date of delivery.  Notice of a defective part must be received in writing at 
Handy Division of Janco Industries, Inc. within  one (1)  year of purchase. All defective parts must be returned to Handy 
Industries and which, upon our examination any parts which are defective in manufacture or workmanship, will be 
replaced or put in good operating condition.  This warranty does not apply to damage resulting from accident, improper 
installation, repair, operation or maintenance, negligence or neglect. The cost of such replacement or repair shall be 
exclusive remedy for any breach of any warranty and Handy Industries shall not be liable to any person for consequential 
damage, or injury, or commercial loss resulting from any breach of warranty.  Handy Industries makes no warranty or 
merchantability, makes no warranty of fitness for a particular purpose and makes no other warranty expressed or implied, 
including implied warranty arising from the course or dealing or usage of the trade. 
 
 
 
 

Summary of Contents for 21660

Page 1: ...and which upon our examination any parts which are defective in manufacture or workmanship will be replaced or put in good operating condition This warranty does not apply to damage resulting from accident improper installation repair operation or maintenance negligence or neglect The cost of such replacement or repair shall be exclusive remedy for any breach of any warranty and Handy Industries s...

Page 2: ...op at the front of the lift then take mount 21630 21665 if mounting to Gruntavore Lift and place it under the lift top Use 6 3 8 bolts provided to bolt through the mounts securing them to the lift top Please see diagram below for bolting configuration NOTE Customer may need to drill additional holes in their lift top depending on the age of the lift If so use mount 21625 as a template to mark hole...

Page 3: ...First put shim on stud followed by handle Then install washer and retaining nut provided DO NOT OVERTIGHTEN NUT Tighten nut by hand using an end wrench DO NOT use impact wrench Twisting off the stud voids winch warranty Raise lift arm slightly by cranking winch clockwise this will allow room to place support tube 21633 into 21610 Use 2 provided 1 2 bolts lock washers and nuts to secure the support...

Page 4: ... procedure will allow the rear tires to roll freely 4 Be sure the safety lever is engaged on the lift before operating The safety lock should be in the ON position for lock to engage in detent teeth 5 Rotate the handle clockwise to raise lift to desired height 6 To lower the lift Raise lift enough to release pressure on safety lock Move lever to OFF position Turn the crank handle counter clock wis...

Reviews: