Following these guidelines will help ensure that your Taoglas
TGX45 antenna is installed correctly. The TGX45 can be
mounted via in 3 different variations;wall mount, pole mount
and suction cup mount. All mounting methods are outlined
below.
TGX45 Series
MIMO 5G/4G Antenna
Installation Instructions
Introduction
Installation Requirements
Antenna Components: Mounting Plate (x1), Tightening Nut (x1), Antenna Housing (x1), Coaxial Cable(x2)
IG-20-08-008-A
www.taoglas.com
•
Pole Mount:
7mm [9/32”] socket wrench or screwdriver, metal mounting clamp (x2)
Pole Diameter Range: 22mm [0.9”] - 50mm [2”]
Metal Mounting Clamp Max Torque: 4 Nm [35in-lb]
•
Wall Mount:
Screwdriver, drill, M4 [Gauge 8] screw (x4), M4 [Gauge 8] washer (x4), 6mm [1/4”] wall mount stud (x4)
•
Suction Cup Mount:
D40 Suction cups (x4)
All copyrights, trademarks and any other intellectual property rights related are owned by Taoglas Group Holdings Limited.
Waiver: This document represents information compiled by Taoglas to the best of our current knowledge. This is not intended to be used as a
representation or warranty of fitness of the products described for any particular purpose. This document details guidelines for general information
purposes only. When planning installations, always seek specialist advice and ensure that the products are always installed by a properly qualified installer
in accordance with applicable regional laws and regulations.
Caution
To comply with FCC RF Exposure requirements in section 1.1310 of the FCC Rules, antennas used with this device must be installed
to provide a separation distance of at least 20 cm from all persons to satisfy RF exposure compliance.
Warning
Do not Operate the transmitter when someone is within 20 cm of the antenna.
Do not operate the equipment in an explosive atmosphere.
European Waste Electronic Equipment Directive 2002/96/EC
Please ensure that your old Waste Electricals and Electronics are recycled do not throw them away into standard waste.
Notices
