© Tait Limited December 2013
www.taitradio.com
402-00082-02
T02-00004-0101/T02-00004-0102 Handset
Installation Instructions
Introduction
The T02-00004-0101/T02-00004-0102 handsets improve
the audio quality in noisy environments, and provide the
user with privacy (Private Handset Mode programmed).
The T02-00004-0101 has a 10ft (3m) handset-to-radio
cable, and the T02-00004-0102 has a 20ft (6m) cable. The
kits are otherwise identical.
When your radio receives a call and the handset is mounted
in its locking cradle, you can hear the call from your radio’s
internal speaker, and also from any connected remote
speaker.
If you remove the handset from its cradle when you receive
a call, you can hear the call from your radio’s internal
speaker, from any connected remote speaker, and from the
handset earpiece.
If private handset mode is programmed, the radio’s internal
and external speakers are muted, and the call can only be heard from the handset earpiece.
The handset uses an electret microphone, and comes with the handset-to-radio cord pre-
wired to the handset mounting plate.
If fitting the handset to a TM8200 remote installation that uses components from kit
TMAA03-16, the existing head and body remote interfaces don’t support audio feed to
the microphone socket and therefore can’t be used with the handset. If fitted on the radio,
the TMAA03-16 kit can be identified by radio body interface, which doesn’t have a con-
nector fitted on the right-hand port. For correct operation, the installation should be
upgraded to one of the enhanced remote kits such as TMAA03-19.
Handset Installation
1 Press the push-button and remove the handset from the locking cradle.
2 Disassemble the locking cradle by removing the four locking cradle screws.
3 Drill a hole for the handset-to-radio cord in the chosen mounting surface, and pass the
cord through the hole. The hole must be large enough for the grommet to fit through.
If a smaller hole is required, remove the handset-to-radio cord from the handset PCB
connector, and drill a hole in the mounting surface just large enough to fit the handset to
radio cord.
locking
cradle
push-
button
handset
grommet
handset-to-
radio cord
mounting
plate
