1
QSG Diode Pointer Ver 2.1
a Novanta company
Diode Pointer Quick Start Guide
Important
Note:
Diode Pointer Unpacking and Installation Preparation:
Read all
Danger,
Warning,
Caution terms, symbols, and instructions located
on our website. The diode pointer provides a safety measure by enabling operators
to monitor the location of the CO
2
beam. Reference the Diode Pointer Specifications
located on our website
https://www.synrad.com/products/accessories/visible-di-
1.
Remove the Diode Pointer from it’s packaging and set aside. Take note of the box contents.
The pointer has both near and far field adjustments set at the factory. If alignment is still required after
installation, see the following sections for guidance. If your SYNRAD® laser is shipped with a Diode Pointer
installed, it is also factory pre-aligned and ready for operation.
2.
Upon arrival, inspect all shipping containers for signs of damage. If you discover shipping damage,
document the damage (photographically if possible), then immediately notify the shipping
carrier (responsible party for any transportation damage) and SYNRAD.
3.
Remove the two dust covers. One of the covers is on the front of the Diode Pointer face, the other is on
the back.
Click here to see an instructional video
, also reference the following figures.
Failure to
remove can
damage the
laser!
1.1
Collect the required tools per the Installa-
tion Instructions included in your box and
remove the two dust cover(s) one in front
and another in the back.
Warning
Serious
personal
injury
Assure the laser and the diode pointer are
turned off during install.
