Swiftech Inc., 1703 E. 28
th
St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769
Parts list
Parts
QTY
PARTS
QTY
MCW5000-64™ base plate
1
Aluminum tension limiter
2
6-32 x 1 ¾ Philips screw
2
Springs
2
Nylon shoulder washers
2
Arctic Alumina Thermal compound
1
4-40 socket screws
4
Hex wrench
1
MCW5000 replacement gasket
1
Stainless steel frame
1
Nylon
spacers
2
This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to
your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their installation. The
following instructions are subject to change without notice. Please visit our web site at
www.swiftnets.com
for updates.
6-32 x 1 3/4" philips
Nylon shoulder washer
Spring
Aluminum tension
limiter
4-40 socket screw
Stainless steel frame
Nylon spacer
Housing gasket
Copper base plate
4-40 x 3/8" socket
screw (use existing)
MCW5000-64™ water-block
installation diagram
Method 1:
The MCW5000-64 water-block bolts
onto AMD’s validated plastic retention
frame with two screw spring
assemblies. Please use the retention
frame provided by your motherboard
vendor. Remove the two existing
screws that hold the frame in place,
place the water-block assembly onto
the CPU, and use these two holes to
bolt down the spring assemblies, as
shown in figure 6, page 2. Each spring
assembly features an aluminum
spacer acting as a tension limiter. It’s
main purpose is to guarantee that
each springs is compressed to the
exact same amount of tension (35lbs
each).
.
Page 1 of 2
