1
2
3
EP-320X-R serial 100/10M Ethernet PCI Adapter
R
B
G
3-Pin Header
Boot Rom Socket (optional)
Controller Chipset
LED
RJ-45
One Ethernet PCI adapter
Driver Diskette
One User's Guide
Wake On LAN Cable (optional)
Each card is clearly displayed below with major components.
This User's Guide is used for the EP-320X-R serial 100/10M
PCI adapter with wake on LAN function which supports M/
B with PCI 2.1 spec. It is a 32-bit adapter for using in
personal computers with a Peripheral Component Inter-
connect (PCI) computer bus to eliminate I/O bottlenecks
and to reduce CPU loading using bus master architecture.
Wake on LAN (for PCI 2.1) function supports you to turn
on PCs from a sleep state over the network remotely during
off-hours.
It is
a Full-Duplex
adapter connected to an Ethernet net-
work with a single connection over unshielded twisted pair
(UTP) cable and can auto-sense either 10 Mbps or 100
Mbps by
full auto-detection
.
Single-chip controller complies to PCI local bus
specification revision 2.1,2.2
Conform with IEEE 802.3 10BASE-T and
IEEE 802.3u 100BASE-TX standards
Support Wake on LAN function (Work with PCI 2.1
motherboard)
Support ACPI, PCI power management (Work with
PCI 2.1/PCI 2.2 motherboard)
High performance bus master architecture for low CPU
and bus utilization
Single RJ-45 connector for using at either 10 or 100Mbps
speed
On-board socket for an optional remote boot ROM
Provide diagnostic LED to monitor linking status
Provide high performance network drivers such as ODI,
NDIS, NDIS3,NDIS4, NDIS5, UNIX, etc.
Support PCI 2.1 For Wake on LAN Function
(With Cable)
NOTE: This 3-pin header is for PCI 2.1 Wake on LAN
function. You must connect WOL cable to this pin header
as Red wire in Red pin header, Black wire in Black pin
header, and Green wire in Green pin header.
n
R: Red
n
B: Black
n
G: Green
LED Indicator
The LED indicators on the rear bracket of each card for
tracking network linking status When working on PCI 2.1
for
Wake On LAN
LINK/ACT
The LED ON indicates green when the card
is connected to 100/10M network. The
LED indicators flash when there is trans
mission of data occurring at the card.
Introduction
Key Features
Package Contents
The Card Layout
LINK/ACT
RJ-45 JACK
