Included with your S2 Scope:
A. #10 serrated Bellville washer (1)
B. #10 flat spacer washer (1)
C. 10-32 hex nut with 3/8” hex (1)*
D. 10-32 hex nut with 5/16” hex (1)*
*Extra parts included for mounting to
various other sights
E. .035” hex key wrench (1)
F. .050” hex key wrench (1)
G. 10-32 x 1 1/8 Socket head cap screw (1)
H. 10-32 threaded rod (1)*
For more info visit:
www.fieldlogic.com
www.sureloc.com
or scan the QR codes:
A.
C.
E.
F.
H.
G.
B.
D.
10. Install bottom fiber cover set
screw using the .035” hex key wrench
(E). Be sure pin is straight and tighten.
This set screw will also hold the pin
in place.
11. Insert fiber into the opposite
fiber routing hole.
12. Put top fiber cover back on by
inserting the ends of the fiber cover
into the routing holes push to secure.
Ensure fiber is routed properly so it
doesn’t get pinched in this step.
13. Install the top fiber cover set
screws using the .035” hex key
wrench (E) until snug.
14. Using the .050” hex key wrench (F),
start the level set screws using an equal
number of turns on each side. Insert
level into level channel. Tighten set
screws to hold level in place.
Be sure not to over-tighten.
14.
10.
11.
13.
12.
S2 SCOPE Instructions
SURE-LOC
