StrombergCarlson.com • 231.947.8600
INS-2021BL-C 01.26.2022
Bunk Ladders
LA-2021460, LA-2021460B, LA-2021466, LA-2021466B
FIGURE 1
PROUDLY MADE IN THE USA
FIGURE 2
FIGURE 3
Bunk Ladders
Models: LA-2021460, LA-2021460B,
LA-2021466, LA-2021466B
Thank you for purchasing the RV Bunk Ladder
by Stromberg Carlson.
Please read all directions prior to installation. When
assembled and used properly, this ladder will provide many
years of trouble-free service. This kit contains components and
hardware for one complete bunk ladder. Complete the following
easy steps and it will be ready for use.
Tools Needed
#2 Phillips screwdriver
7/16” wrench
Tape Measure and pencil (if installing brackets)
Masking tape (if trimming tube length)
Hacksaw or fine tooth saw (if trimming tube length)
Carton Contents
(Figure 1)
(2) pc 1” diameter x 60” or 66” tubing with rubber foot
already installed
(4) pc ladder treads
(2) pc hooks
(2) pc brackets
(8) sets fasteners for treads
(8) pc 1/4” x 1-3/4” bolts
(8) pc 1/4” flat washers
(8) pc 1/4” nylon lock nuts
(2) sets of #10-barrel combo fasteners
(2) pc 1” #10-barrel body nuts
(2) pc #10 x 5/16” bolt
4 pc screws #10 x 1” screws for bracket mounting
1. Using the 1/4” x 1-3/4” long bolts, 1/4” flat washers and 1/4”
lock nuts, attach the treads to the upright tubes.
(Figures 2 & 3)
• There is a slight divot in the side face of each tread. Use
this divot to face all treads in the same direction when
attaching to the tubes.
• The dimples in the upright tubes should face away from
the tread (the punched hole that is smooth should sit
next to the tread), with the bolts penetrating through the
dimpled side of the tubing into the tread end.
