Page 1 of 3
Inlet Connection
RO Inlet Connection
Pure Water Connection
Waste Water Connection
300GPD-F RO FILTRATION SYSTEM
This 300 GPD filtration system is very efficient at reducing water hardness and is simple to install and
maintain.
It is the installer’s responsibility to ensure that this appliance is plumbed in accordance with local authority’s
bye-law regulations.
INSTALLATION INSTRUCTIONS
Unscrew the three vertical filter bowls and remove the wrapping from the cartridges and reassemble.
A filter spanner is included in the kit for loosening the filter bowls. Do not over tighten filter bowls
when re-assembling.
The white nylon hosetail elbow (optional kit- part no. KIT01302)
allows you to connect standard 1/2” (12mm) hose to the INLET of
the third vertical filter housing. Remove the existing elbow and
simply screw this fitting into the filter. Connect the water supply
hose to this fitting and tighten it on with a jubilee clamp. Connect
the inlet hose to the mains water
supply.(See Fig 1)
Alternatively a Hozelock type connection kit can be purchased to simplify the hose connection. (part
no. KIT 01300 Brass fittings kit or KIT01301 Nylon fittings kit)
Cut and connect a suitable length of ¼” tube to the waste
water connection which is marked
DRAIN. This tube is the waste water
tube and must discharge into the
nearest suitable drain. Cut and
connect a suitable length of ¼”
tube to the joiner from the kit and connect to the white tube
coming from the shut off valve. This must discharge into the
main pure water collection tank. (See Fig 2)
