Manual TOOL F3B
We, Fa.
STRAT
AIR
, congratulate for buying
that model. The Tool F3B is a high
performance F3B model. The model is a full
molded carbon product. Alle parts will be
produced out of high quality molds. The model is nearly ready to fly. Never the less you have to do me finishing
work. Finally we wish you a lot of fun in building an flying the model. The Tool F3B is a fast and agil RC-model.
Take care that the model is always in good technical condition because of the high loads during flight. Be aware that
you fly the model in safe distance of persons and goods.
1. Wing:
Mill a opening into the surface of the movement part (flap, aileron) and put control horns in it. Then glue them.
Picture left = aileron
picture middle= flap
picture right = pushrod cover
In front of the control horn an opening
must be milled to lead the pushrod
through the wing. Use the M2,5
windingrod to connect control horn
with servo. 200mm are enough for the
whole wing. For one pushrod you
need around 45mm of the M2,5 rod.
On both sides screw the M2,5 metal
clevises. Connect (solder) servos with
the preinstalled servocables. In the
middle of the wing, where the servocables are ending, solder the 6-pol MPX connector (female part). That type of
connector fit optimal in the wing-opening. Fix them with a trop of CA.
Summary of Contents for F3B
Page 4: ...6 Technische Daten ...
