STM AUSTRALIA
1/615 WARRIGAL RD
ASHWOOD VIC 3147
AUSTRALIA
T
1300 131 531
F
1300 308 508
E
W
WWW.STM.NET.AU
DG83231
18 Volt 450 Gram Grease Gun
Battery Capacity
1500 mAh
Battery Pack Charge Time
1 Hour
Charger Input Power
230 Vac 50Hz
Battery Output Power
18Vdc
Maximum Operating Pressure
9,500 PSI
(500psi tolerance)
Grease Reservoir Capacity (oz.)
16
Minimum Flow Rate
75
(3 grams tolerance)
Hose
42"
Weight
18.4 lbs
SAFETY INSTRUCTIONS
Failure to follow all instructions listed below may result in electric shock, fire, and/or serious injury. Please read carefully
WORK AREA
1. Keep your work area clean and well lit. Cluttered benches and dull areas muy cause accidents.
2. Do not operate power tools in explosive atmospheres such as in the presence of flammable liquids, gases, or dust.
Power tools create sparks that may ignite the materials.
3. Keep bystanders, children, and visitors away while operating a power tool. Distractions can lead you to lose control.
ELECTRICAL SAFETY
1. Avoid body contact with grounded surfaces such as pipes, couplers. There is an increased risk of electric shock if your
body is grounded.
2. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock.
PERSONAL SAFETY
1.Stay alert. Watch what you are doing and use common sense when operating a power tool. Do not use a power tool while
tired or under the influence of drugs, alcohol, or medication. A moment of intention while operating power tools may
result in serious personal injury
2. Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your hair, clothing, and gloves away from
moving parts. Loose clothes, jewelry, or long hair can be caught in moving parts.
3. Avoid accidental starting. Be sure the Switch is released before plugging in. Carrying power tools with your finger on the
Trigger, or plugging in power tools with the Trigger depressed invites accidents.
4. Remove adjusting keys or wrenches before turning the power tool on. A wrench or a key that is left attached to a
rotating part of the power tools may result in personal injury
5. Do not overreach. Keep proper footing and balance at all times. Proper Tooting and balance enables better control of
the power tool in unexpected situations.
6. Use safety equipment. Always wear approved safety glasses underneath a full face safety shield Dust mask, non-skid
safety shoes, hard hat, or hearing protection must be used for appropriate conditions.
