![background image](http://html1.mh-extra.com/html/stealth-products/twb480-fdm/twb480-fdm_instructions-for-mounting_1368400001.webp)
The TWB480FDM must be mounted so that when the hardware flips back, the protruding hardware clears the top of
the back and does not cause a safety hazard for the client. This is also the best position to achieve maximum adjustability.
See
illustrations below for correct mounting
Incorrect
Correct
Correct
TWB480-FDM
Instructions for mounting & adjusting
Set screws have been added to the hardware for increased stability. When ad-
justing these screws(A), finger tighten until screw stops, then t 1/4 of a turn.
Over tightening these screws will cause hardware breakage. For adjusting the set screw
in the neck of the flip down mechanism(B), only finger tighten screw until secure.
Over tightening this screw will cause flip down mechanism not to function correctly.
Set Screws
Hardware Placement
FDM Screw
This button head screw on opposite side of red
push button cannot be adjusted or removed. Any move-
ment of this screw will cause flip down mechanism not
to function correctly.
Remember to periodically check hardware for loose screws or worn parts. Replace or repair hardware as needed.