Quick-Start Guide
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.
Manual Revision: December 18, 2019 6:37 PM
Product Diagram (M2E1BRU31C)
Exterior
Component
Function
1
Power LED
•
Solid:
Indicates that the
Enclosure
is receiving
power.
•
Flashing:
Indicates that the
Drive
activity.
2
USB-C Port
• Used to connect the
Enclosure
to the
Host
Computer
.
Interior
Component
Function
3
Drive-Bay Screws x 4
• Used to secure the
Drive Bay Cover
in the
Enclosure
.
4
Drive Connector
• Used to connect the
Drive
to the
Enclosure
.
USB 3.2 Gen 2 Type C IP67 Rugged NVMe Enclosure
5
Adjustable Drive
Length Holes
• Used to accommodate different drive lengths.
6
Drive-Mount Screw/
Nut
• Used to secure the
Drive
to the
Enclosure
.
Requirements
For the latest requirements and full manual, please visit
www.startech.com/
M2E1BRU31C
Installation
Warning!
Drives should be handled carefully, especially when they’re transported. If
you’re not careful with your drives, you may lose data as a result.
Installing an 80 mm Drive
1. Using the
Torx Screwdriver
(included), remove the
Drive-Cover Screws
(x 4) from
the bottom of the
Enclosure
and remove the
Cover Plate
.
2. Place the
Drive
next to the
Drive Tray
and align the screw groove on the
Drive
with
the
Adjustable Drive Length Holes
on the
Drive Tray
.
3. Use the
Torx Screwdriver
and to remove the
Drive-Mount Screw
from the
Enclosure
.
4. Gently slide the connector on the
Drive
(on a 30-degree angle) into the
Drive
Connector
on the
Enclosure
.
Note:
The connector on your drive is keyed so that it only fits one way.
5. Lightly push the
Drive
down into position on the circuit board.
6. Insert the
Drive-Mount Screw
through the screw groove on the
Drive
and into the
Drive-Mount Screw Hole
on the
Enclosure
.
7. Using the
Torx Screwdriver
tighten the
Drive-Mount Screw
, being careful not to
over-tighten.
8. Place the
Cover Plate
back onto the bottom on the
Enclosure
. Make sure that the
Cover Plate
is properly aligned with the top of the
Enculosure
creating a tight seal
and that nothing is obstructing the
Cover Plate
, in order to provide a water and
dust resistance seal.
9. Insert the
Drive-Cover Screws
back into the four corner on the bottom of the
Enclosure
.
6
4
5
3
1
2
