Part Number: 3600 / 3650
Page 1
Version 1.0
© 2016 Starkey Products, Inc.
2015-2017 Ford Mustang V6 OEM-Style Fog Light Kit
Parts List:
Quantity:
Tool List:
LED Foglights/ Bezels
2
•
Flat head & Phillips screwdriver
(if you ordered part#3600)
•
Ratchet & Socket set OR
Wiring harness
1
•
Adjustable Wrench
Ford OEM Switch
1
•
Wire stripping tool or razor blade
PB-3600 Parts Bag
1
Thank you for purchasing one of our products. Please familiarize yourself with the parts included as well
as the instructions before attempting installation. Please seek the help of a certified technician if you feel
unable to complete the installation safely and properly. Failure to read and follow the instructions below
may result in personal injury or damage to property. Starkey Products, Inc. and our retailers assume no
liability for failures to comply with guidelines and warnings outlined in this instruction manual.
If you are receiving this instruction manual with part #3650 (Starkey Fog Light Wiring & Switch Kit),
skip to the ‘Wiring in Engine Bay’ section on page 2. Otherwise, begin steps immediately below.
Fog light installation into bumper:
Removing the bumper is not necessary. Driving the vehicle onto ramps or raising the front end of the
car will greatly ease installation. Before beginning the steps below, turn off the car, remove key, and
engage the emergency brake.
1.
Open hood of car and make sure hood is held open securely.
2.
Removing the air deflector will allow you access to fog light mounting points. The air deflector is
held on by 16 screws and 6 push pins (shown as dots in picture 1 below). Use a ratchet & 7mm
socket OR wrench to remove the screws. The pins are removed with a flat head screwdriver - pry
up on center part of the pin and then pry up on the body of the pin. See picture 2. The deflector is
removed by pulling back/ down gently. Set aside hardware and deflector for re-attachment later.
3.
Use flathead screwdriver to remove the push pin shown in picture 3 on each front wheel well.
This push pin helps hold on the left and right side bezel. Save for re-installation later.
4.
Unplug turn signal connectors on each side. You will reuse your existing turn signal lamps.
Remove air deflector. It is held by 16
screws/ 6 push pins (shown as dots).
Pry up on center part of pin first. Then
pry out entire push pin.
Remove push pin shown on right and
left side front wheel well.
