SP Controls Application Note
PLUS U2-1200
Revision B
I. Driver Features
1. Command Format
This device is controlled through a combination of RS-232 and IR commands; both are necessary for full
control of the device.
2. RS-232 Commands
IR Commands
Power On
Power Off
Volume Up
Volume Down
Source: Video
Source: S-Video
Source: RGB
Source: DVI
Zoom Up
Zoom Down
Focus Up
Focus Down
Menu
Adj Up
Adj Down
Adj Left
Adj Right
Enter
Cancel
A/V Mute
Freeze
Zoom
Keystone
Up
Down
Lamp Mode
3. Other Driver Features
Default Power Status Feedback
:
Projector Restart Lockout Timer (Default)
:
None
150 Seconds
II. RS-232 Control Wiring
For IR wiring, see product manual for the SP Controls device.
Wire RS-232 control to a male DB9 as shown. Connect DB9 cable to PLUS serial adapter cable (must be
separately ordered from PLUS, part no. TCB-769760000).
Connect the PLUS adapter cable to projector small USB port near the audio connector on the back of the
projector. See Part IV. below for more information on locating the communication port.
Serial Adapters
(for NRC only): A & B
III. Projector Configuration and Additional Information
Warning
: The PLUS serial adapter cable (P/N: YCB-C- 769760000) contains active electronics.
Ringing
it out with a continuity meter may damage the adapter cable.
•
SPLASH SCREEN DISPLAY OFF
: To disable Splash Screen display, navigate through the on-screen
menus to
Setup,
inside the
Options
menu set the
On Screen
menu option to OFF.
•
AUTO SOURCE OFF
: To disable Auto Source,navigate through the on-screen menus to
Setup
and set
Auto Source
to OFF.
© 2004-9 SP Controls Inc.
SP Controls reserves the right to modify specifications without notice at any time.
GND to 5
RX to 2
TX to 3
SP Controls
Device
Control Cable
(shown from front)
